Tempco
Tempco MBH20548 band heater 120V 6 in 200 W 900 °F
A mica-insulated band heater delivers 200 W at 120 V for 6 in diameters up to 900 °F
- 120 V supply for standard mains compatibility
- 6 in diameter fits common pipe sizes
- 200 W output with 34 W/sq in density for efficient conduction heating
- Mica insulated steel construction conserves electrical energy and extends heater life
- 10/32 screw terminals on same side simplify wiring and installation
Tempco MBH20548 band heater for 6 in diameter
The Tempco MBH20548 is a mica insulated steel band heater designed for 120 V operation with a 6 in inside diameter. It delivers 200 W at a density of 34 W/sq in and reaches a maximum temperature of 900 °F. The unit uses 10/32 screw terminals located on the same side for wiring.
Flexible construction simplifies fitting onto
The heater is fully flexible, allowing it to wrap around the target surface for easy installation. Built-in thermal insulation conserves electrical energy and minimises heat loss. Ensure the mounting surface is clean and the band is tightened evenly to maintain good temperature uniformity and prevent hot spots.
Verify voltage, diameter
Confirm the supply is 120 V and the application can accommodate a 2 in wide band with a 6 in inside diameter. Check that the 10/32 screw terminals on the same side are accessible in your enclosure. The width tolerance is ±1/16 in, so allow for this variation when planning the installation.
Highlights
- 120 V supply for standard mains compatibility
- 6 in diameter fits common pipe sizes
- 200 W output with 34 W/sq in density for efficient conduction heating
- Mica insulated steel construction conserves electrical energy and extends heater life
- 10/32 screw terminals on same side simplify wiring and installation
Specifications
| Brand | TEMPCO |
|---|
Questions about this item
How can I confirm the band heater is operating correctly once installed?
Verify the unit reaches up to 900 °F and draws approximately 10 A at 120 V; the 34 W/sq in watt density should produce even heating across the 6 in diameter surface.
What comes with the MBH20548 and what must I source separately?
The heater includes built-in thermal insulation and 10/32 screw terminals on the same side; you will need to supply mounting hardware and wiring to match the termination.
Which specification should I match when selecting this model for my application?
Choose the MBH20548 when you need a 120 V, 200 W mica-insulated band heater with a 6 in inside diameter, 2 in width and 900 °F maximum temperature.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
