Tempco
Tempco HDL00035 Cartridge Immersion Heater 7-1/4 in 240V 2000W
A 2,000 W cartridge immersion heater with Incoloy sheath and brass screw plug for water heating
- 2000 W output heats water fast
- Incoloy sheath resists corrosion in water
- Brass screw plug fits 3/4 in NPT ports
- 148 W/sq in density delivers concentrated heat
- Epoxy-sealed leads protect wiring to 266 °F
Cartridge Immersion Heater 2000W
The Tempco HDL00035 is a cartridge immersion heater rated at 2000 watts for 240V AC single-phase supply. It is built for direct heating of water in industrial or commercial tanks and process vessels.
2000W capacity with 148 W/sq in density
At 148 watts per square inch the sheath delivers high heat flux for fast temperature rise in water. The control range reaches 266 degrees F, so the unit covers most hot-water process set-points but will not suit applications needing higher temperatures.
Incoloy sheath with brass screw plug
The Incoloy sheath resists corrosion in water while the brass 3/4 inch NPT screw plug provides a secure tank connection. Minimum immersion depth is 6 1/4 inches and an epoxy seal at the lead end protects the electrical entry during normal operation.
Highlights
- 2000 W output heats water fast
- Incoloy sheath resists corrosion in water
- Brass screw plug fits 3/4 in NPT ports
- 148 W/sq in density delivers concentrated heat
- Epoxy-sealed leads protect wiring to 266 °F
Specifications
| Brand | TEMPCO |
|---|
Questions about this item
Will the 3/4 in NPT screw plug fit the existing brass boss on my older tank?
The brass screw plug uses a standard 3/4 in NPT thread that matches most legacy tank bosses; verify the boss is also NPT and not BSPT before threading.
How do I confirm the 2000 W heater is reaching the 266 °F control range after wiring it to 240 V single-phase power?
With power applied, the sheath should stabilise near 266 °F; use a calibrated surface probe on the Incoloy sheath at the minimum 6 1/4 in immersion depth to verify.
Does the box include the PTFE flange gasket and epoxy-sealed leads, or must I order them separately?
The unit ships with the PTFE flange, brass screw plug and epoxy-sealed lead ends already assembled; no extra sealing parts are required for water immersion.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
