Tempco
Tempco CSF00110 Fin Strip Heater 240V 450W 35 7/8 in 1200 Deg F hvac control
A finned strip heater delivering 450 W at 240 V AC with a maximum sheath temperature of 1,200 °F
- 240 V AC supply suits industrial power systems
- 450 W output with 31 W/sq in density
- 1 200 °F max sheath temperature for demanding heat
- 304 stainless steel sheath resists corrosion
- Surface-mount tabs with slotted holes simplify installation
HVAC Fin Strip Heater 240V 450W
This finned strip heater operates at 240V AC and delivers 450W of heating power. It is built for surface-mount installation in HVAC control systems where consistent radiant and convective heat is required. The UL Recognized component suits industrial and commercial equipment builders.
Thermal Profile 31 W/sq in Sheath 1200 Deg F
The heater runs at a watt density of 31 W/sq in with a maximum sheath temperature of 1200 Degrees F. The 304 stainless steel sheath and nickel-plated steel fins dissipate heat across a 1 3/8 by 2 inch finned cross-section. Normal operation stays within these thermal limits without forced airflow.
Sustained Load Surface Mount 35 7/8 in
Under continuous duty the 35 7/8 inch overall length and 34 7/8 inch mounting centres keep the element stable through thermal cycling. Offset terminals and 10-32 slotted mounting tabs simplify wiring and secure attachment. The single-phase design maintains steady output without cyclic derating.
Highlights
- 240 V AC supply suits industrial power systems
- 450 W output with 31 W/sq in density
- 1 200 °F max sheath temperature for demanding heat
- 304 stainless steel sheath resists corrosion
- Surface-mount tabs with slotted holes simplify installation
Specifications
| Brand | TEMPCO |
|---|
Questions about this item
How do I mount the Tempco CSF00110 fin strip heater and which step is often missed?
Surface-mount the heater using the included mounting tabs and 10-32 screws through the 1/2 in by 5/16 in slotted holes, then tighten to the 34 7/8 in mounting dimension — skipping the slotted-hole alignment causes uneven expansion and premature sheath failure.
What maintenance or replacement will the Tempco CSF00110 fin strip heater need over time?
Plan to replace the entire strip when the 304 stainless-steel sheath reaches its 1,200 °F limit or if the nickel-plated steel fins corrode, because the 450 W element and offset terminals are not field-serviceable.
What is the first limit that appears when the Tempco CSF00110 runs continuously at full power?
The 31 W/sq in watt density drives the sheath to its 1,200 °F maximum temperature first, so sustained operation beyond that point triggers the UL-recognized thermal limit and requires derating or forced-air cooling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
