We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aluminium heatsink with 9 cm dual-ball PWM fan for GTX1060

SXDOOL

SXDOOL GTX1060 graphics card cooler 123x97x34mm 58mm pitch 9cm dual ball 4-pin PWM fan PLA09215B12H

SKU CH-H1GX-4NVS5

Cools NVIDIA 1060 cards with 123x97x34mm aluminum heatsink, 58mm hole pitch, 9cm dual-ball 4-pin PWM fan at 12V 0.55A

  • Aluminium heatsink transfers heat efficiently from the graphics processor
  • 123x97x34mm radiator footprint matches compatible board layouts
  • Four mounting holes on a 58mm pitch align with stock cooler positions
  • 9cm dual-ball-bearing PWM fan runs on 12V 0.55A power
  • 4-pin interface enables automatic speed control via the graphics card

Replacement cooler for GTX1060

This 9 cm dual-ball-bearing PWM fan with an aluminium heatsink is built as a direct drop-in replacement for reference-design GTX1060 cards. The 12 V 0.55 A motor connects through a standard graphics-card 4-pin header so speed control works without adapters.

Suits owners of reference GTX1060 boards

Builders whose cards use a different hole pattern, a larger heatsink assembly, or a non-standard power connector cannot use this cooler. It is also unsuitable for multi-fan shrouds that rely on a single large heatsink spanning the full PCB length.

Mounting pitch is 58 mm across four holes

Measure the distance between the centres of the four mounting holes on your existing cooler; only a 58 mm square pattern will align with this unit's brackets. If the pitch differs, the cooler cannot be secured.

Highlights

  • Aluminium heatsink transfers heat efficiently from the graphics processor
  • 123x97x34mm radiator footprint matches compatible board layouts
  • Four mounting holes on a 58mm pitch align with stock cooler positions
  • 9cm dual-ball-bearing PWM fan runs on 12V 0.55A power
  • 4-pin interface enables automatic speed control via the graphics card

Specifications

No published specifications for this item yet.

Questions about this item

What does the 4-pin PWM interface on the PLA09215B12H fan control?

The 4-pin PWM connector lets the graphics card regulate the 12V 0.55A fan speed automatically based on GPU temperature.

Will the 58mm hole pitch and 123x97x34mm radiator fit my card's mounting holes?

This cooler uses a four-hole 58mm pitch on a 123x97x34mm aluminum radiator; verify your board matches those exact mounting dimensions.

How do I install the dual-ball-bearing fan without damaging the 4-pin header?

Align the keyed 4-pin connector vertically, press straight down until seated, then secure the 58mm-pitch screws — forcing the plug sideways bends the header pins.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.