Suntec
Suntec Oil Burner Pump 1725 rpm 3 gph 100-150 psi
Delivers 3 gph at 100–150 psi with 1725 rpm motor speed for oil-burner systems
- Delivers precise fuel flow at 3 gph for consistent combustion
- Adjustable 100-150 psi pressure range matches varied burner requirements
- 1725 rpm motor speed ensures reliable, steady pump operation
- Single-stage design simplifies installation and reduces maintenance points
- UL Listed certification confirms compliance with recognised safety standards
Suntec Oil Burner Pump 3 gph
This Suntec oil burner pump delivers a 3 gph flow rate at 1725 rpm for residential and light-commercial heating systems. It operates within an adjustable pressure range of 100 to 150 psi to suit varying burner requirements. The unit is UL Listed for safety compliance.
Single-stage construction with adjustable pressure
A single-stage design simplifies installation and routine maintenance on compatible oil-fired equipment. The adjustable pressure range lets technicians set output between 100 and 150 psi without replacing the pump. Standard mounting dimensions allow direct replacement of many existing Suntec units.
Check lift height and piping configuration
Verify that your installation does not exceed a maximum lift of 14 ft in a two-pipe system or 8 ft in a one-pipe system. Confirm the burner motor runs at 1725 rpm to match the pump speed rating. Ensure the fuel line and fittings are rated for the 100 to 150 psi operating pressure.
Highlights
- Delivers precise fuel flow at 3 gph for consistent combustion
- Adjustable 100-150 psi pressure range matches varied burner requirements
- 1725 rpm motor speed ensures reliable, steady pump operation
- Single-stage design simplifies installation and reduces maintenance points
- UL Listed certification confirms compliance with recognised safety standards
Specifications
| Brand | Suntec |
|---|
Questions about this item
What is the adjustable pressure range of the Suntec Oil Burner Pump?
The pump delivers an adjustable pressure range of 100 to 150 psi, capping the maximum output pressure at 150 psi for oil burner systems.
What are the overall dimensions needed to mount this pump?
The unit measures 3 1/4 inches in height, 2 1/4 inches in length, and 4 3/8 inches in width, requiring a mounting footprint that accommodates these clearances.
How is the pump installed and what is the common piping mistake?
Install by connecting the inlet and outlet ports to the fuel line; the step often missed is configuring the internal bypass plug correctly for either a 1-pipe or 2-pipe system to match the installation type.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
