We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue amplifier wiring kit with line output converter and coozy

STINGER

STINGER SS600XS 8GA 600W Wiring Kit with AudioControl LC1i 2-Channel LOC

SKU CH-155Z-7HTJS

Factory-integration bundle combines an 8 GA copper 600 W amplifier wiring kit with an AudioControl LC1i two-channel line output converter featuring 40 V speaker-level input handling

  • TypeLine Output Adapters
  • Complete 600 W amplifier install with all wiring included
  • LC1i active converter handles 40 V speaker-level signals
  • Selectable 20, 60, 20k input impedance matches any factory system
  • Clean 9.5 V preamp output with 0.01 % distortion
  • GTO signal sensing turns amp on without remote wire

Complete Factory Integration Bundle

This package combines an AudioControl LC1i active two-channel line output converter with a Stinger SS600XS 8-gauge copper wiring kit rated for 600 watts. The LC1i accepts speaker-level signals up to 40 volts and provides preamp outputs up to 9.5 Vrms with adjustable gain. It is designed for drivers adding an aftermarket amplifier to a factory source unit without RCA outputs.

Build Quality and Daily Implications

The LC1i features selectable input impedance at 20, 60, or 20k ohms plus a ground isolation switch to suppress noise. GTO signal sensing creates a 12-volt remote turn-on output automatically when audio is detected. The wiring kit supplies 8-gauge copper power and ground conductors, fuse holder, and terminals for a tidy installation. A compact chassis allows placement behind the dash or in tight cavities.

Compatibility Checks Before Ordering

Verify your factory speaker wires can reach the LC1i mounting location and that the 40-volt maximum input covers your head unit's output. Confirm the 150-ohm preamp output impedance matches your amplifier's input requirements. Ensure the 120-milliamp current draw is acceptable for your vehicle's accessory circuit. Buyers who need more than two channels of conversion or a higher-voltage preamp output should consider a different solution.

Highlights

  • Complete 600 W amplifier install with all wiring included
  • LC1i active converter handles 40 V speaker-level signals
  • Selectable 20, 60, 20k input impedance matches any factory system
  • Clean 9.5 V preamp output with 0.01 % distortion
  • GTO signal sensing turns amp on without remote wire

Specifications

TypeLine Output Adapters

Questions about this item

What is the maximum speaker-level input voltage the LC1i can handle?

The LC1i accepts up to 40 Vrms speaker-level input, rated for 400 W on the 20 k setting.

What gauge power wire does the SS600XS kit supply for a 600 W amplifier?

The kit includes 8-gauge copper power and ground wire sized for a 600 W system.

How is the LC1i turned on without a separate remote wire?

Use GTO signal sensing or audio sense on the speaker inputs; the unit then activates its 12 V remote output automatically.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.