Steelman
Steelman 60394 25-Foot 3/8" ID Rubber Air Hose 1/4" NPT Brass Fittings
A 25-foot rubber air hose with 3/8-inch ID and 1/4-inch NPT brass fittings, rated for 300 PSI working pressure and 1200 PSI burst pressure, stays flexible from -40F to 180F and resists oil.
- Delivers full tool power with 3/8-inch ID airflow
- Resists kinking and abrasion with polyester-reinforced rubber
- Handles extreme cold and heat from -40F to 180F
- Rated for 300 PSI working pressure and 1200 PSI burst
- Brass 1/4-inch NPT fittings connect easily to tools
Steelman 60394 Rubber Air Hose
The Steelman 60394 is a 25-foot rubber air hose with a 3/8-inch inside diameter built for pneumatic tools in workshops and garages. Its polyester fibre-reinforced construction resists kinking and stands up to abrasion on concrete floors while an oil-resistant core tube meets RMA class C standards. The hose stays flexible from -40F to 180F and handles a working pressure of 300 PSI with a 1200 PSI burst rating.
Brass NPT Fittings Ready to Use
Pre-attached 1/4-inch NPT male brass fittings let you connect the hose to compressors, adapters or additional lengths without extra parts. Brass resists corrosion and the threads seal reliably under normal shop pressures so you can start work straight away. The reinforced rubber also resists damage from most common shop chemicals.
Check Fitting Compatibility and Pressure Needs
Verify that your compressor and tools accept 1/4-inch NPT threads before ordering because the hose ends are fixed. Ensure your system's maximum pressure does not exceed 300 PSI working pressure to stay within the hose rating. Note the Proposition 65 warning that this product contains chemicals known to the State of California to cause cancer and reproductive harm.
Highlights
- Delivers full tool power with 3/8-inch ID airflow
- Resists kinking and abrasion with polyester-reinforced rubber
- Handles extreme cold and heat from -40F to 180F
- Rated for 300 PSI working pressure and 1200 PSI burst
- Brass 1/4-inch NPT fittings connect easily to tools
Specifications
| Brand | STEELMAN |
|---|
Questions about this item
How often should the 3/8-inch ID rubber hose be inspected or replaced under heavy shop use?
Inspect the polyester-reinforced rubber cover and brass NPT fittings before each shift; replace the hose if you see cover cracks, deep abrasion, soft spots on the oil-resistant core tube, or any fitting corrosion or thread damage.
What pressure limit will be reached first during continuous operation?
The hose is rated for 300 PSI working pressure with a 1200 PSI burst rating; sustained use should stay at or below 300 PSI to avoid exceeding the working-pressure limit.
How hot does the hose get and does it stay flexible during all-day use?
The rubber compound remains flexible from -40°F to 180°F, so the hose will not stiffen in a cold shop or soften excessively when ambient temperatures rise during extended runs.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
