Steelman
Steelman 50049-IND 25-Foot 3/8" ID Air Hose with 1/4" NPT Brass Fittings
A 25-foot polyurethane air hose with reusable brass fittings rated to 100 PSI
- Reach tools across the workshop with 25-foot length
- Resists scrapes on concrete floors with abrasion-resistant polyurethane
- Handles twists and crushes without kinking
- 25% lighter than rubber for easier handling
- Withstands up to 100 PSI working pressure
25-Foot 3/8" ID Air Hose
The Steelman 50049-IND is a straight, uncoiled polyurethane hose built for pneumatic tools in garages, workshops and industrial settings. Its 25-foot length provides reach across a typical work area without the bulk of a coiled design. The hose suits technicians who need a lightweight, abrasion-resistant line for daily compressed-air tasks.
Reusable 1/4" NPT Brass Fittings
Premium polyurethane construction outmatches rubber and nylon for wear resistance, especially on unfinished or bare concrete floors. The material is highly kink resistant and withstands twisting or crushing during regular use. Pre-attached reusable brass fittings connect directly to 1/4-inch NPT quick connects, adapters and compressors for a secure, leak-free seal.
Up to 100 PSI Working Pressure
The hose handles working compressed air pressures up to 100 PSI, covering most shop compressor outputs. At 25% lighter than equivalent rubber hoses, it reduces operator fatigue during extended use. Flexible polyurethane keeps noise and vibration low while maintaining consistent airflow. Not suited for applications requiring pressures above the rated limit or for users needing a self-retracting coil design.
Highlights
- Reach tools across the workshop with 25-foot length
- Resists scrapes on concrete floors with abrasion-resistant polyurethane
- Handles twists and crushes without kinking
- 25% lighter than rubber for easier handling
- Withstands up to 100 PSI working pressure
Specifications
| Brand | STEELMAN |
|---|
Questions about this item
What maximum working pressure does the 3/8-inch ID hose handle?
The hose is rated for up to 100 PSI of compressed air pressure.
What thread size must my compressor or quick-connect have to mate with the pre-attached fittings?
The reusable brass ends are 1/4-inch NPT, so the mating port must also be 1/4-inch NPT.
How do I secure the reusable fittings if I ever need to reattach them, and what mistake should I avoid?
Thread the fitting onto the hose by hand, then tighten with a wrench on the brass hex; do not over-tighten or you can strip the threads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
