SQUARE D
SQUARE D HOM150 Circuit Breaker HOMELINE 50A 1 Pole 120/240V
Single-pole 50 A breaker for Homeline load centres, 10 kA interrupting capacity, box-lug terminals accept 8–2 AWG Cu/Al
- Fast installation with plug-in mounting design
- Standard circuit protection rated 50 A at 120/240 VAC
- 10 kA breaking capacity for reliable fault interruption
- HACR rated for heating, air conditioning and refrigeration circuits
- Box lug terminals accept 8 AWG to 2 AWG copper or aluminum wire
50 A HOMELINE Breaker
This Square D HOM150 is a single-pole miniature circuit breaker rated 50 A at 120/240 VAC for use in HOMELINE load centres. It provides standard branch-circuit protection with a 10 kA interrupting rating and HACR marking for heating, air-conditioning and refrigeration equipment.
50 A Capacity and 10 kA Interrupting
The breaker handles continuous loads up to 50 A on a single pole and will interrupt fault currents up to 10 kA. It is not suitable for circuits requiring two-pole or three-pole protection, higher amperage ratings or interrupting capacities beyond 10 kA.
Plug-In Mounting with Box Lugs
The plug-in design installs directly into compatible HOMELINE panels. Box-lug terminals accept one conductor per pole in a wire range of 8 AWG to 2 AWG copper or aluminium. The unit measures 3.13 inches high, 1.0 inch wide and 2.98 inches deep and carries UL listing.
Highlights
- Fast installation with plug-in mounting design
- Standard circuit protection rated 50 A at 120/240 VAC
- 10 kA breaking capacity for reliable fault interruption
- HACR rated for heating, air conditioning and refrigeration circuits
- Box lug terminals accept 8 AWG to 2 AWG copper or aluminum wire
Specifications
| Brand | SQUARE D |
|---|
Questions about this item
Will the HOM150 fit in my existing Homeline load center alongside older breakers?
Yes, this 1 pole breaker uses the standard Homeline plug-in mounting and is designed to plug directly into Homeline load centers, so it installs alongside existing Homeline breakers without modification.
How can I verify the HOM150 is working correctly after installation?
After wiring the box lugs with 8 to 2 AWG copper or aluminum wire, switch the handle to ON; the breaker should remain latched under normal load up to 50 A and trip only on overcurrent, confirming the 10 kA interrupting rating is active.
What comes with the HOM150 and what must I supply?
The breaker itself is supplied; you must provide 8 to 2 AWG copper or aluminum conductors for the box-lug terminals and a compatible Homeline load center for the plug-in mounting.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
