Spyder
Spyder 400002 Brush Attachment 4.5 in
Brush attachment fits reciprocating saws for cleaning brick, carpet, concrete, grout, laminate, rubber and tile with a 1/2 in shank
- Cleans multiple surfaces with one tool
- Fits 1/2 in shank reciprocating saws
- 5 in steel brush reaches tight areas
- Single-piece design simplifies changeovers
- Ready for brick, carpet, concrete and more
Spyder 400002 Brush Attachment
The Spyder 400002 is a 4.5 in brush attachment designed for use with reciprocating saws. It targets professionals and DIY users who need to clean or prepare surfaces such as brick, carpet, concrete, grout, laminate, rubber and tile. The steel construction provides durability for demanding surface preparation tasks. This single piece accessory expands the versatility of a compatible reciprocating saw.
Half inch shank fits compatible reciprocating saws
The attachment uses a 1/2 in shank that fits directly into compatible reciprocating saws without additional adapters. Its 4.5 in length and 2 in width allow access to a variety of flat or contoured surfaces. The design frees the operator from manual scrubbing by converting the saw's reciprocating motion into powered brushing action. No other tools or modifications are required for installation.
Steel bristles maintain stiffness under continuous
The steel bristles resist deformation during sustained surface cleaning on brick, concrete or tile. Continuous reciprocating motion keeps the brush effective without the rapid wear seen in softer materials. Heat buildup remains low because the attachment has no motor or electronics of its own. Performance stays consistent across extended jobs on grout, laminate or rubber surfaces.
Highlights
- Cleans multiple surfaces with one tool
- Fits 1/2 in shank reciprocating saws
- 5 in steel brush reaches tight areas
- Single-piece design simplifies changeovers
- Ready for brick, carpet, concrete and more
Specifications
| Brand | SPYDER |
|---|
Questions about this item
How long is the brush attachment and will it reach deep grout lines?
The brush measures 4.5 in long and 2 in wide, sized for grout, tile and similar surfaces.
Does the steel brush generate noticeable heat or vibration during extended reciprocating-saw use?
Steel bristles on a 1/2 in shank run cool with minimal vibration when matched to the saw's stroke rate.
Will the 1/2 in shank fit my reciprocating saw without an adapter?
The 1/2 in shank fits standard reciprocating-saw chucks directly, no adapter required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
