SPEEDAIRE
SPEEDAIRE 2YNL9 Exhaust Muffler 0.25 in NPT 160 cfm 300 psi
Removes oil mist from exhaust air at 160 cfm and 300 psi with a .9 micron filter and .25 in NPT inlet
- Filters oil mist to 0.9 micron for cleaner exhaust
- Handles 160 cfm flow for high-volume pneumatic systems
- Rated to 300 psi for demanding compressed-air applications
- Aluminium and polypropylene body resists corrosion and heat
- 25 in NPT inlet fits standard 1/4-inch airline connections
SPEEDAIRE 2YNL9 Exhaust Muffler
The SPEEDAIRE 2YNL9 is an exhaust muffler designed to remove oil mist from compressed air lines. It suits workshops and industrial sites that need cleaner exhaust discharge from pneumatic tools or compressors. The unit handles a maximum flow of 160 cfm at pressures up to 300 psi. Its 0.9 micron filter rating captures fine oil particles before air exits the system.
Quarter-inch NPT inline installation
The muffler connects via a 0.25 in NPT tube inlet for direct inline mounting on existing plumbing. Aluminium and polypropylene construction resists corrosion while keeping weight low. One air inlet simplifies routing in tight compressor cabinets or on portable rigs. No extra fittings are included so installers can match thread sealant to their pipework.
Sustained 160 cfm at 300 psi
Under continuous demand the filter media maintains its 0.9 micron rating up to the 300 psi limit. Maximum operating temperature of 160 Degrees F allows use on compressors that run hot during extended cycles. The housing materials do not degrade when exposed to oil-laden exhaust air over long shifts. Pressure drop stays consistent because the single inlet path avoids internal turbulence.
Highlights
- Filters oil mist to 0.9 micron for cleaner exhaust
- Handles 160 cfm flow for high-volume pneumatic systems
- Rated to 300 psi for demanding compressed-air applications
- Aluminium and polypropylene body resists corrosion and heat
- 25 in NPT inlet fits standard 1/4-inch airline connections
Specifications
| Brand | SPEEDAIRE |
|---|
Questions about this item
How much oil mist can the .9 micron filter remove during continuous operation?
The filter is rated at .9 micron and is designed to capture oil mist from the exhaust air stream as it passes through the aluminum and polypropylene body.
Does the muffler body get hot when running at 300 psi and 160 cfm all day?
The maximum operating temperature is 160 Degrees F, so the housing will reach that temperature under sustained full-load conditions.
Which thread size must my compressor port have to accept the 0.25 in NPT inlet?
The unit requires a 1/4 in NPT female port on the compressor or tool for direct installation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
