Spartan Power
Spartan Power 2 foot 1/0 AWG Battery Cable Set 3/8" Ring
Two-foot 1/0 AWG battery cable set with 3/8-inch ring terminals, UL-listed and rated to 1000 V
- 2 ft length suits tight battery compartments
- 1/0 AWG pure copper handles high current loads
- 3/8 in ring terminals fit common battery posts
- UL 1232 1284 1338 1346 10269 rated for up to 1000 V
- Lifetime crimp warranty covers repair for life
2-Foot 1/0 AWG Battery Cable Set
This 2-foot cable set uses 1/0 AWG conductors terminated with 3/8-inch ring terminals. It is built for high-current DC wiring in RVs, marine craft, fleet trucks, golf carts, solar installations and inverter connections. The pure-copper construction suits on-grid and off-grid power distribution where low voltage drop matters.
Sustained Load Behaviour
Cables carry UL 1232, 1284, 1338, 1346 and 10269 approvals and are rated for up to 1000 V continuous operation. VW-1 flame rating and moisture-resistant insulation maintain integrity under prolonged high-amperage draw. Adhesive-lined irradiated polyolefin heat shrink seals each termination against corrosion and vibration over long service periods.
Upgrade Context
The set replaces thinner gauge leads that limit inverter output or cause excessive voltage drop on long runs. It is not for buyers who need longer reach without adding junctions or who require a different terminal hole pattern. The lifetime crimp warranty covers the factory assemblies for the life of the installation.
Highlights
- 2 ft length suits tight battery compartments
- 1/0 AWG pure copper handles high current loads
- 3/8 in ring terminals fit common battery posts
- UL 1232 1284 1338 1346 10269 rated for up to 1000 V
- Lifetime crimp warranty covers repair for life
Specifications
| Brand | SPARTAN POWER |
|---|
Questions about this item
Does the 1/0 AWG cable generate noticeable heat when carrying continuous load all day?
The cable uses UL-approved 1/0 AWG copper rated for 1000 V, so heat rise stays minimal under normal continuous current.
What terminal size must my battery posts accept for the 3/8" ring terminals to fit?
Each cable end has a 3/8-inch ring terminal, so your battery posts or bus bars need 3/8-inch clearance holes.
Will the adhesive-lined heat-shrink hold up on older battery posts that may have surface corrosion?
The irradiated polyolefin shrink with adhesive lining seals over cleaned posts, but heavy corrosion should be removed first for a reliable bond.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
