Southwire
Southwire M500CX4 Coax Continuity Tester/Mapper electrician tool
Tests coax cable continuity and maps up to four remote locations with colour-coded IDs and a simple LED display
- TypeTest Equipment
- Easy-to-understand LED display shows continuity status instantly
- Tests both patch cables and installed coax runs
- Maps up to four remote locations with included color-coded remotes
- Simple operation speeds up cable identification tasks
- Compact tester fits in tool pouch for on-site use
Simple Coax Mapping Tool
The Southwire M500CX4 is a dedicated coax continuity tester and mapper built for electricians and installers who need to verify cable runs quickly. An easy-to-understand LED display shows results at a glance without complex menus. It identifies up to four remote locations using the included colour-coded ID remotes. The unit works on both patch cables and permanently installed wiring.
Continuity-Only Verification Limits
The tester confirms electrical continuity and maps remote endpoints but does not measure signal loss, impedance or shielding quality. It cannot certify bandwidth for high-frequency data or video standards beyond a basic continuity pass. Results are limited to the four remotes supplied, so larger installations require multiple test passes. No tone generation or cable-length measurement is provided.
Pre-Installation Compatibility Checks
Verify that the cables under test use standard F-type connectors compatible with the tester ports. Ensure all four colour-coded remotes are present before starting a mapping job. Confirm the LED display is visible in the intended work lighting conditions. The tool requires no external power source, so battery condition is not a factor.
Highlights
- Easy-to-understand LED display shows continuity status instantly
- Tests both patch cables and installed coax runs
- Maps up to four remote locations with included color-coded remotes
- Simple operation speeds up cable identification tasks
- Compact tester fits in tool pouch for on-site use
Specifications
| Type | Test Equipment |
|---|
Questions about this item
How do I choose between the different remote identifiers included with the M500CX4?
The tester comes with four color-coded ID remotes that let you map up to four separate coax cable runs at once; pick the colour that matches the location you are testing.
What does the LED display actually show when I connect a cable?
The easy-to-read LEDs indicate continuity status for each connected remote, so you can immediately see which of the four cable paths are complete or open.
Does the M500CX4 use a standard coax connector type for testing?
It connects directly to standard F-type coax terminations on patch cables or installed wiring, letting you verify continuity without adapters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
