Sony
Sony LMP-F370 Projector Lamp 370W UHP 210W Bulb Housing
Replacement projector lamp module with a 210 W UHP bulb rated for 4,000 hours standard or 10,000 hours economic mode
- TypeUHP
- Wattage370W
- Ready to install with pre-assembled bulb and housing
- 370 W UHP lamp delivers 210 W bulb brightness
- Up to 4000 hours in standard mode
- Up to 10000 hours in economic mode
- Built to ISO 9001 quality standards
Direct replacement lamp module
The Sony LMP-F370 module delivers a complete 370 W UHP lamp assembly with a 210 W bulb already fitted inside its housing. It is built for owners of compatible Sony projectors who need a drop-in replacement without separate bulb handling.
Factory-assembled housing simplifies service
The unit arrives as a single sealed cartridge manufactured to ISO 9001 quality checks covering beam output, ignition voltage, connections and run-time. No tools or alignment steps are required beyond opening the projector door and sliding the module into place.
Restores original brightness and runtime
The lamp is rated for 4000 hours in standard mode and 10000 hours in economic mode, matching the projector’s factory specifications. The upgrade is worthwhile when the existing lamp dims, flickers or reaches its hour limit, and a full housing swap eliminates the risk of mis-seated bare bulbs.
Highlights
- Ready to install with pre-assembled bulb and housing
- 370 W UHP lamp delivers 210 W bulb brightness
- Up to 4000 hours in standard mode
- Up to 10000 hours in economic mode
- Built to ISO 9001 quality standards
Specifications
| Brand | Sony |
|---|---|
| Type | UHP |
| Wattage | 370W |
Questions about this item
What projector interface does the LMP-F370 lamp use and what power does it draw?
The lamp is a UHP type rated at 370W total power with a 210W bulb inside the housing.
What physical parts are included so the module fits my projector?
The module arrives as a fully assembled bulb and housing unit, ready to slot into the projector's lamp compartment.
How do I install the LMP-F370 and which step often causes errors?
Power off and cool the projector, open the lamp door, remove the old module, insert the new assembly until it seats firmly, close the door, then reset the lamp timer in the menu.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Tripp Lite U324-003-BK USB 3.0 cable USB-A to USB-A 3 ft
- USB
- Black


