Sola/Hevi-Duty
Sola/Hevi-Duty SDP0624100T 24/28V DC 15 W 0.6 A DIN Rail line protection
DIN-rail DC supply delivers 24–28 V at 0.6 A from 85–264 V AC input with IP20 protection
- Wide input range 85 to 264V AC suits global supplies
- Adjustable 24 to 28V DC output fits varied loads
- 15 W output with low 50mV ripple protects sensitive gear
- DIN rail mount 2.95 in high saves panel space
- Green LED status indicator shows power at a glance
Industrial DC power supply for control panels
The Sola/Hevi-Duty SDP0624100T delivers a regulated 24 to 28V DC output at 0.6 A from an 85 to 264V AC input. It is built for DIN rail mounting inside enclosures rated to IP20 and NEMA 1. The 15 W switching unit suits automation, sensor loops and low-power PLC circuits.
Snap-on DIN rail install with basic wiring
The plastic case clips onto standard DIN rail without tools and measures 2.95 in high by 0.9 in wide by 3.8 in deep. A green LED confirms output presence. Installers must verify the single-phase supply falls within 47 to 63 Hz and that the load stays below 0.6 A to avoid nuisance tripping.
Steady 15 W output with 25 ms ride-through
Under continuous load the supply maintains output noise below 50 mV and holds voltage for more than 25 ms if the mains falters. The wide input range absorbs voltage swings without shutting down. It is not sized for motors, heaters or any load that exceeds the 15 W rating.
Highlights
- Wide input range 85 to 264V AC suits global supplies
- Adjustable 24 to 28V DC output fits varied loads
- 15 W output with low 50mV ripple protects sensitive gear
- DIN rail mount 2.95 in high saves panel space
- Green LED status indicator shows power at a glance
Specifications
| Brand | SOLAHD |
|---|
Questions about this item
How do I confirm the SDP0624100T is operating correctly after wiring it?
After applying 85 to 264V AC input, the green LED status indicator will illuminate to show the 24 to 28V DC output is active and within regulation.
What comes with the SDP0624100T and what must I source separately?
The power supply unit is included; you must supply the AC input cable, the DIN rail for mounting, and the DC output wiring to your load.
Which SDP series model should I select for a 15 W, 0.6 A DIN rail application?
The SDP0624100T provides 24 to 28V DC at 0.6 A with a 15 W rating, matching those exact requirements.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
