SMUGDESK
SMUGDESK USB 2.0 Type-A Male to Female Flat FPC Extension Cable 200cm
A 200 cm flat FPC cable extends a USB 2.0 Type-A port with 480 Mbps data and power for hidden routing in FPV, storage, scanner or printer setups
- Ultra-thin FPC ribbon hides neatly in tight spaces
- USB 2.0 delivers 480 Mbps data and steady power
- 200 cm length reaches distant FPV or office gear
- Male-to-female Type-A extends any standard USB port
- Works with drones, drives, scanners, printers and daily peripherals
USB 2.0 flat FPC extension
This 200 cm flat FPC cable extends a standard USB 2.0 Type-A connection with an ultra-thin ribbon profile. It is built for installers who need to route a data and power link through tight gaps, behind panels or along drone frames where round cables cannot fit. The male-to-female layout plugs directly into existing ports without adapters.
480 Mbps bandwidth and 200 cm reach
The cable carries USB 2.0 signalling at 480 Mbps while delivering the bus power required by typical peripherals. It handles scanners, printers, external hard disks and FPV gear at full specification speed across the full two-metre length. Runs that exceed this distance or demand USB 3.x throughput will need a different solution.
Fits tight routing, frees standard ports
The slim flexible ribbon slips under carpet edges, inside enclosures or along carbon-fibre arms, leaving the host Type-A socket accessible for other devices. No driver installation is required and the passive design adds no active components to the signal path. Builds needing right-angle connectors, locking shells or ruggedised jackets are not addressed by this cable.
Highlights
- Ultra-thin FPC ribbon hides neatly in tight spaces
- USB 2.0 delivers 480 Mbps data and steady power
- 200 cm length reaches distant FPV or office gear
- Male-to-female Type-A extends any standard USB port
- Works with drones, drives, scanners, printers and daily peripherals
Specifications
No published specifications for this item yet.
Questions about this item
Will the 200cm flat FPC cable reach from my rear motherboard USB 2.0 port to a front-panel hub without signal loss?
The 200cm length is designed for long-distance USB 2.0 extension and supports the standard 480Mbps data rate across the full run.
How can I verify the 480Mbps link is active after I route the ribbon cable?
Check the operating system device manager or system profiler; the connected peripheral should enumerate at USB 2.0 high speed (480Mbps).
Does the package include only the male-to-female flat cable or any mounting hardware?
The package contains the 200cm USB 2.0 Type-A male-to-female flat FPC extension cable; no mounting clips or extra adapters are included.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Tripp Lite U324-003-BK USB 3.0 cable USB-A to USB-A 3 ft
- USB
- Black


