We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green printed circuit board FX-102 with electronic components, 220V 70W wine cooler control board

SMUGDESK

SMUGDESK FX-102 Wine Cooler Control Board 220V 70W

SKU CH-APWV-QBQ1T

Replacement control board for wine coolers, rated 220V 70W with 12.5V PCB operation

  • 220 V operation matches standard mains supply
  • 70 W power rating supports typical wine cooler compressors
  • 5 V PCB logic ensures stable controller performance
  • FX-102 model targets direct replacement compatibility
  • Supplied as a single complete board for immediate installation

What This Board Replaces

This SMUGDESK FX-102 control board runs wine coolers that require a 220 V supply and a 70 W power rating. It is a direct PCB swap for units marked PCB121110K1 and arrives brand new in a single-piece pack.

Installation Notes

Replacing the board means disconnecting mains power, removing the old PCB, and matching every connector to the photo supplied by the vendor. Misaligned plugs or a loose earth wire are the most common reasons the cooler will not start after the swap.

Voltage and Power Limits

The board accepts 220 V AC input and drives a 12.5 V DC load up to 70 W. It cannot be used on 110 V supplies or with compressors that draw more than the rated wattage, and no higher-voltage or higher-current variants are offered in this listing.

Highlights

  • 220 V operation matches standard mains supply
  • 70 W power rating supports typical wine cooler compressors
  • 5 V PCB logic ensures stable controller performance
  • FX-102 model targets direct replacement compatibility
  • Supplied as a single complete board for immediate installation

Specifications

No published specifications for this item yet.

Questions about this item

How can I verify the SMUGDESK FX-102 control board is working correctly after installation?

After fitting the board, power the cooler and confirm the compressor starts and the interior temperature begins to drop toward the set point; the display should show normal read-outs without error codes.

What comes in the box with the FX-102 board and what extra parts might I need?

The package contains one PCB121110K1 control board; you may need to reuse the existing wiring harness, temperature sensor and mounting screws from the original unit.

Which version of the FX-102 board should I choose for a 220 V, 70 W wine cooler?

Select the board marked FX-102 PCB121110K1 rated for 220 V input and 70 W output with a 12.5 V PCB operating voltage.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.