Smith-Cooper
Smith-Cooper Banded Coupling 1-1/2" Pipe FNPT Malleable
A Zoro Select 1-1/2" FNPT malleable coupling rated to 300 psi for joining pipe sections
- 1-1/2" FNPT malleable coupling connects pipes securely
- 300 PSI pressure rating handles demanding plumbing systems
- ZORO SELECT brand ensures consistent manufacturing quality
- New condition guarantees unused, factory-fresh components
- Manufacturer part 4316000362 simplifies reordering and identification
1-1/2" FNPT Malleable Banded Coupling
This ZORO SELECT banded coupling connects two 1-1/2 inch FNPT pipe ends in plumbing installations. The malleable iron construction provides mechanical strength for threaded joint assemblies. It is suited for residential and light commercial piping systems where a secure female-threaded connection is required.
Replacing worn or leaking threaded couplings
Use this fitting when an existing 1-1/2 inch FNPT coupling shows corrosion, thread damage or leakage at the joint. The 300 pressure-class rating supports typical water, air and inert gas lines within its design limits. The upgrade is worth it when the old fitting can no longer maintain a tight seal under normal operating pressure.
Simple thread-on installation with pipe sealant
Apply appropriate thread sealant or tape to the male pipe threads before engaging the coupling. Tighten to the recommended torque for 1-1/2 inch NPT to avoid cracking the malleable iron. The most common issue is cross-threading or over-tightening, which damages threads and creates leak paths.
Highlights
- 1-1/2" FNPT malleable coupling connects pipes securely
- 300 PSI pressure rating handles demanding plumbing systems
- ZORO SELECT brand ensures consistent manufacturing quality
- New condition guarantees unused, factory-fresh components
- Manufacturer part 4316000362 simplifies reordering and identification
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
What pipe size and thread type does the 1-1/2" FNPT malleable coupling fit?
It connects to 1-1/2 inch pipe with female NPT threads on both ends.
How is the banded coupling installed and which step is often missed?
Clean threads, apply sealant, hand-tighten, then wrench-tighten; the step often missed is using the correct sealant for NPT threads.
When should the malleable iron coupling be inspected or replaced?
Inspect periodically for corrosion, cracks, or leaks; replace if any damage is found or after system pressure tests fail.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



