Slugger By Fein
Slugger By Fein 63134302042 Annular Cutter 1 3/16 in 2 in pneumatic accessory
High-speed steel annular cutter with 1 3/16 in diameter and 2 in cutting depth
- 1 3/16 in diameter cuts precise holes
- 2 in maximum depth handles thick material
- High-speed steel construction resists wear
- Bright finish reduces friction during cutting
- 3/4 in Weldon Flat shank fits standard holders
Slugger By Fein Annular Cutter
The Slugger By Fein 63134302042 annular cutter is a high-speed steel tool for magnetic-base drilling machines. It cuts 1 3/16 inch diameter holes to a maximum depth of 2 inches in structural steel. The Weldon flat shank fits 3/4 inch tool holders on compatible magnetic drills.
Thermals noise and power in use
Heat generated during cutting is managed by the high-speed steel body and external coolant supplied by the magnetic drill. The cutter itself produces no electrical noise; operational sound comes from the drill motor and chip evacuation. Power draw depends entirely on the host pneumatic or electric drill unit.
Build quality and day-to-day fit
Bright-finish high-speed steel resists wear in mild and structural steel. The 3/4 inch Weldon flat shank locks securely in standard magnetic drill arbors for quick changes. The 2 inch cutting depth suits plate, beam and pipe work. Not suited for hand-held drills or machines without a Weldon arbor.
Highlights
- 1 3/16 in diameter cuts precise holes
- 2 in maximum depth handles thick material
- High-speed steel construction resists wear
- Bright finish reduces friction during cutting
- 3/4 in Weldon Flat shank fits standard holders
Specifications
| Brand | SLUGGER BY FEIN |
|---|
Questions about this item
How do I install the Slugger By Fein annular cutter and what step is often missed?
Insert the 3/4 in Weldon Flat shank into the arbor and tighten both set screws firmly against the flat surfaces; the step often missed is engaging the second screw, which prevents the cutter from spinning loose under load.
What maintenance or replacement will the Slugger By Fein 63134302042 cutter need later?
The high-speed steel teeth dull with use; plan to resharpen or replace the cutter once cutting speed drops or the hole finish degrades, and always clear chips after each cut to extend edge life.
What limit appears first on the Slugger By Fein annular cutter during sustained cutting?
The 2 in maximum cutting depth is the hard stop; feeding beyond that depth binds the slug, stalls the motor and ruins the cutter, so never exceed the rated depth in a single pass.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
