Slugger By Fein
Slugger By Fein 63127624110 carbide annular cutter 1-3/8 x 3 in
Carbide annular cutter drills 1-3/8 inch holes to 3 inch depth with Weldon shank
- Carbide construction resists wear for longer tool life
- Bright finish reduces friction and chip build-up
- 3 in cutting depth handles thick plate in one pass
- Weldon flat shank locks securely in magnetic drills
- 3/4 in shank fits common industrial tool holders
Slugger By Fein 63127624110 carbide annular cutter
This annular cutter is built for magnetic-base drills and other machines that accept a 3/4 in Weldon flat shank. It is suited for fabricators and maintenance crews cutting structural steel, plate or pipe where a solid carbide tooth geometry extends tool life in abrasive or hardened materials. The 1-3/8 in diameter produces a clean slug rather than a full chip load, reducing horsepower demand on the drive unit.
Carbide teeth and bright finish
The carbide tips resist heat and wear far longer than high-speed steel when cutting tough alloys or layered plate. The bright, uncoated surface avoids coating delamination in high-heat cuts and allows easy resharpening on standard equipment. A 3 in maximum cutting depth lets the tool reach through thick flanges or double plates in a single pass, eliminating the need for step drilling or multiple tool changes.
Weldon flat shank installation
The 3/4 in Weldon flat seats directly into standard magnetic-drill arbors with a set-screw lock, so no adapter sleeves are required. Ensure the set screw engages the flat securely; a loose screw lets the cutter walk and damages both the shank and the workpiece. Verify that the machine spindle runs true — excessive run-out chips the carbide tips within the first few seconds of the cut.
Highlights
- Carbide construction resists wear for longer tool life
- Bright finish reduces friction and chip build-up
- 3 in cutting depth handles thick plate in one pass
- Weldon flat shank locks securely in magnetic drills
- 3/4 in shank fits common industrial tool holders
Specifications
| Brand | SLUGGER BY FEIN |
|---|
Questions about this item
When will the carbide teeth on this 1-3/8 inch annular cutter need replacement?
Replace the cutter when the carbide teeth become dull or chipped, which reduces cutting speed and hole quality in steel.
What limits continuous cutting depth with this 3 inch maximum depth annular cutter?
The 3 inch maximum cutting depth is the limit; deeper holes require a longer cutter or multiple passes.
How much heat does the bright finish carbide cutter generate during all-day drilling?
The bright finish carbide design resists heat buildup, but cutting fluid is recommended to manage temperature during extended use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
