We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass male adapter with push-fit ends, 1.85 in long

SharkBite

SharkBite UIP120 1/2" Push-to-Connect Brass Male Adapter

SKU CH-2TKR-8X0CB

A 1/2" push-to-connect brass male adapter rated for 200 psi and 200°F, measuring 1.85" long with IAPMO, NSF and UPC compliance

  • Push-fit connection installs without tools or solder
  • Brass construction resists corrosion in water systems
  • Rated for 200 psi at 200°F service conditions
  • Certified to IAPMO, NSF and UPC standards
  • Compact 1.85-inch length fits tight spaces

Brass push-fit male adapter

The SharkBite UIP120 is a 1/2 inch brass male adapter that uses a push-to-connect design for copper, CPVC or PEX pipe. It suits residential and light-commercial plumbing repairs where soldering, glue or crimp tools are impractical.

Tool-free installation with depth-mark check

Push the pipe straight into the fitting until it stops; the internal grab ring and O-ring seal without wrenches. The most common error is not inserting the pipe to the full depth mark, which leaves a leak path under pressure.

Verify pipe type, pressure and temperature limits

Confirm the existing pipe is 1/2 inch copper, CPVC or PEX and that the system operates below 200 psi and 200 degrees F. The fitting carries IAPMO, NSF and UPC compliance marks, but it is restricted from sale in California due to Proposition 65 chemical warnings.

Highlights

  • Push-fit connection installs without tools or solder
  • Brass construction resists corrosion in water systems
  • Rated for 200 psi at 200°F service conditions
  • Certified to IAPMO, NSF and UPC standards
  • Compact 1.85-inch length fits tight spaces

Specifications

BrandSHARKBITE

Questions about this item

How do I confirm the SharkBite UIP120 is sealing correctly after installation?

Pressurise the line up to 200 psi and inspect the joint; no water should escape from the push-fit connection.

What comes with the SharkBite UIP120 and what must I supply myself?

The box contains the brass male adapter only; you must provide 1/2 in pipe and any thread sealant for the male end.

Which SharkBite push-fit adapter should I choose for a 1/2 in copper line rated to 200 Degrees F?

This UIP120 model matches 1/2 in pipe, handles 200 psi and 200 Degrees F, and carries IAPMO, NSF and UPC listings.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.