We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass push-to-connect male adapter, 1 inch, 2.4 inches long

SharkBite

SharkBite 1" Push-to-Connect Brass Male Adapter

SKU CH-4W34-M6YQS

A 1-inch push-fit brass male adapter rated for 200 psi and 200 °F with a 2.4-inch fitting length

  • Push-fit design enables fast installation without tools
  • Brass construction resists corrosion for long service life
  • Rated to 200 psi and 200 °F for demanding systems
  • Certified to IAPMO, NSF and UPC standards for code compliance
  • Compact 2.4 in length fits tight plumbing spaces

SharkBite 1" Brass Male Adapter

This SharkBite push-to-connect brass male adapter joins 1-inch pipe without soldering, crimping or glue. It is suited for residential and light-commercial plumbing repairs where a quick, code-compliant connection is needed. The fitting meets IAPMO, NSF and UPC standards for potable-water and hydronic-heating systems.

Pressure and temperature limits

Rated for a maximum pressure of 200 psi and a maximum temperature of 200 degrees F, the adapter handles typical hot and cold water lines. Brass construction resists corrosion and scale build-up under normal operating conditions. No external power or tools are required, so noise and energy draw are not factors.

California Proposition 65 notice

The product carries a Proposition 65 warning for chemicals known to the State of California to cause cancer and reproductive harm. No additional software, seals or specialised tools are bundled with the fitting. Installers should follow local code requirements for push-fit connections in concealed spaces.

Highlights

  • Push-fit design enables fast installation without tools
  • Brass construction resists corrosion for long service life
  • Rated to 200 psi and 200 °F for demanding systems
  • Certified to IAPMO, NSF and UPC standards for code compliance
  • Compact 2.4 in length fits tight plumbing spaces

Specifications

BrandSHARKBITE

Questions about this item

How deep must the 1 in pipe be pushed onto the push-fit end, and what step do people skip?

Push the pipe in until it stops — about 2.4 in total fitting length — then pull back slightly to lock the teeth; skipping the pull-back test leaves the joint loose.

Which component will need replacement first on a hot-water line?

The internal O-ring and stainless-steel grip ring degrade fastest at temperatures approaching 200 °F, so plan to swap the adapter if the joint weeps after years of sustained heat.

At what pressure does the brass body become the limiting factor during continuous use?

The adapter is rated to 200 psi; running a system at or above that pressure for long periods will stress the brass before the push-fit seal fails.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.