Senco
Senco BC58 Stapler 1/2 in Crown 21 ga 110 Capacity
Air-powered stapler driving 21-gauge, 1/2-inch crown staples up to 5/8-inch leg length with a 110-capacity magazine for industrial roofing work
- Industrial-duty construction withstands heavy daily use
- 110-staple magazine reduces reload frequency on the job
- Bump-fire trigger speeds repetitive fastening tasks
- Operates from 60 to 95 psi with standard shop air
- Lightweight aluminum housing eases overhead and extended work
Senco BC58 Button Cap Stapler
The Senco BC58 is an air-powered staple gun built for industrial roofing work. It drives 21 gauge crowned staples with a 1/2 in. crown and 5/8 in. leg length. The magazine holds 110 staples and 110 caps for continuous fastening. An aluminum housing keeps the tool light on the roof.
Roofing crews needing consistent cap fastening
This stapler suits professional roofers who fire crowned staples all day at 95 psi. It is not for finish carpenters who need depth adjustment for flush countersinking. It is not for hobbyists without a compressor delivering 0.77 cfm through a 3/8 in. hose. It is not for jobs requiring sequential fire only.
110 staple and cap magazine capacity
The combined 110-count magazine sets how long you work before reloading. At 95 psi maximum pressure the tool seats caps flush in a single bump-fire stroke. A 1/4 in. NPT inlet and top exhaust complete the air connection.
Highlights
- Industrial-duty construction withstands heavy daily use
- 110-staple magazine reduces reload frequency on the job
- Bump-fire trigger speeds repetitive fastening tasks
- Operates from 60 to 95 psi with standard shop air
- Lightweight aluminum housing eases overhead and extended work
Specifications
| Brand | SENCO |
|---|
Questions about this item
Will the 1/4 in NPT air inlet on the BC58 connect to my existing 3/8 in hose and compressor?
Yes, the tool requires a 1/4 in NPT inlet and a minimum 3/8 in hose, so your current hose size is compatible; just add the correct 1/4 in NPT fitting.
How do I confirm the stapler is firing correctly at the 95 psi maximum after I hook it up?
Set the regulator to 95 psi, load a strip of 1/2 in crown 21 ga staples, engage the bump-fire trigger against the workpiece and verify consistent staple depth and full 110-count magazine feeding.
Does the box include the 1/2 in crown 21 ga staples and the 1/4 in NPT fitting, or must I buy them separately?
The stapler ships with the tool only; 1/2 in crown 21 ga staples and a 1/4 in NPT air fitting are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
