Senco
Senco 6S0041N SFT10XP-F 1/2-in 20-Gauge Fine Wire Stapler 110-192 capacity
Drives 20-gauge fine-wire staples from 3/16 to 1/2 inch at 60–95 psi with a 110–192 capacity magazine
- TypeAir Nailers
- Heavy-duty steel cap reduces recoil for better control
- One-handed magazine opening cuts reload time
- Rear exhaust directs oil and dust away from the work
- 110 to 192 staple capacity supports long runs without stopping
- Operates at 60 to 95 psi with .77 cfm air consumption
Industrial Upholstery Stapler
The Senco 6S0041N SFT10XP-F is a pneumatic fine-wire stapler built for industrial upholstery work. It drives 20-gauge crowned staples with leg lengths from 3/16 in to 1/2 in using a sequential firing mode. A heavy-duty steel cap provides superior balance and minimal recoil during extended use.
110 to 192 Staple Capacity
The magazine holds between 110 and 192 staples depending on the specific strip length loaded. This capacity supports long runs of fabric or insulation attachment before a reload is required. The one-handed magazine opening reduces downtime when the supply runs out. Rear exhaust directs oil and dust away from the workpiece.
1/4-in NPT Air Inlet
The tool connects to a compressed air supply via a 1/4 in NPT inlet and requires a minimum 1/4 in hose size. Operating pressure ranges from 60 to 95 psi with an air consumption of .77 cfm. The aluminum housing keeps the unit light at 6 1/2 in overall height. Depth control is not featured on this model.
Highlights
- Heavy-duty steel cap reduces recoil for better control
- One-handed magazine opening cuts reload time
- Rear exhaust directs oil and dust away from the work
- 110 to 192 staple capacity supports long runs without stopping
- Operates at 60 to 95 psi with .77 cfm air consumption
Specifications
| Type | Air Nailers |
|---|---|
| Brand | Senco |
Questions about this item
Will the 1/4 in NPT air inlet connect directly to my existing 1/4 in hose fittings?
Yes, the tool uses a standard 1/4 in NPT air inlet that matches common 1/4 in hose fittings for a direct connection.
How can I verify the stapler is firing correctly at the 95 psi maximum pressure?
Fire a test staple into scrap material at 95 psi; the staple should drive flush with consistent depth using the sequential trigger.
Does the box include staples or only the 110 to 192 capacity magazine?
The magazine holds 110 to 192 fine wire staples; staples are sold separately and must match 20 gauge, 1/2 in crown, 3/16 in to 1/2 in leg length.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
