Senco
Senco 15 gauge 2 1/2 inch angled finish nail pack of 3000
15-gauge angled finish nails, 2 1/2 inches long, 34-degree collation, 3,000-count pack for compatible nailers
- TypePower Staplers
- 15-gauge finish nails sized for trim work
- 2-1/2-inch length drives deep into hardwood
- 34-degree collation angle fits angled nailers
- 3000-count pack covers large projects
- Plain steel shank resists bending during driving
Senco 15-Gauge Angled Finish Nails
This pack contains 3000 steel angled finish nails measuring 2 1/2 inches in length with a 15-gauge shank diameter of .072 inches. The nails feature a plain finish, brad head, smooth shank, and conical point collated at a 34-degree angle on tape strips. They are manufactured in the USA for use with compatible 15-gauge angled finish nailers.
Suited for trim carpenters and finish work
These nails suit professionals installing baseboards, crown moulding, chair rails, and door casings where a 15-gauge fastener provides the required holding strength. The 2 1/2-inch length penetrates framing securely through standard trim thicknesses. Builders needing a different gauge, shorter length, or alternative collation angle for their specific tool should look at other fastener options.
34-degree tape collation matches tool requirement
The single specification that decides fit is the 34-degree tape-strip collation combined with 15-gauge wire diameter. Only nailers designed for this exact collation angle and gauge will feed these strips reliably. Verify the tool manual specifies 34-degree 15-gauge angled finish nails before purchasing.
Highlights
- 15-gauge finish nails sized for trim work
- 2-1/2-inch length drives deep into hardwood
- 34-degree collation angle fits angled nailers
- 3000-count pack covers large projects
- Plain steel shank resists bending during driving
Specifications
| Brand | Senco |
|---|---|
| Type | Power Staplers |
Questions about this item
How much heat does the 15 gauge nail generate when the tool runs all day?
The nails themselves produce no heat; only the driving tool warms up during extended use.
Which 15 gauge angled nailer accepts the 34 degree collation angle of this pack?
Any 15 gauge finish nailer designed for 34 degree tape-collated strips will feed these nails.
Will the .072 inch shank diameter seat properly in older 15 gauge finish nailers?
Yes, the .072 inch shank matches the standard 15 gauge specification used by older angled finish nailers.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
