Schneider Electric
Schneider Electric NSYTRV42SF6LD Fused Disconnect Terminal Block 1 Pole 10 A 600 V
A fused disconnect terminal block for DIN-rail mounting, rated 10 A at 600 V with screw-clamp connections for 26 to 8 AWG copper wire and a 1/4 in by 1.25 in fuse
- Engine BrandSCHNEIDER ELECTRIC
- Fused disconnect protects circuits up to 600 V
- Screw clamp terminals accept 26 to 8 AWG copper wire
- Single-pole, two-tier design saves DIN rail space
- CSA, CURus and EAC certified for safety compliance
- Compact 0.4 in width fits dense panel layouts
Schneider Electric NSYTRV42SF6LD Fused Disconnect
This Schneider Electric NSYTRV42SF6LD is a fused disconnect terminal block built for industrial control panels and machinery wiring. It accepts a single pole circuit rated at 10 A and 600 V, providing overcurrent protection directly on the DIN rail. The two-tier housing allows separate feed-through and fuse connections in a compact 0.4 in width. It suits electricians and panel builders who need integrated fuse holders for copper conductors.
Installation notes and common issues
The block mounts on standard DIN rail using a screw-clamp connection for wires from 26 AWG to 8 AWG solid or stranded copper. Installers must verify the cartridge fuse fits the 1/4 in diameter and 1.25 in length specification before closing the lever. A frequent error is exceeding the 10 A rating or using oversized conductors that prevent proper clamp torque. The black housing is CSA certified, CURus and EAC listed for compliance.
Deciding specification: 10 A / 600 V single-pole
The defining limit is the 10 A current rating combined with 600 V maximum voltage on a single pole. If your circuit demands higher amperage or multi-pole disconnection, this block will not meet the requirement. Buyers needing unfused feed-through terminals or higher pole counts should select a different series. The 3.11 in depth and length fit standard panel layouts when space allows.
Highlights
- Fused disconnect protects circuits up to 600 V
- Screw clamp terminals accept 26 to 8 AWG copper wire
- Single-pole, two-tier design saves DIN rail space
- CSA, CURus and EAC certified for safety compliance
- Compact 0.4 in width fits dense panel layouts
Specifications
| Engine Brand | SCHNEIDER ELECTRIC |
|---|
Questions about this item
How can I verify the terminal block is correctly fused and conducting after wiring it to the DIN rail?
After mounting on the DIN rail and tightening the screw clamps, measure continuity across the 1-pole circuit and confirm the 1/4 in × 1.25 in fuse is intact; the block is rated for 10 A at 600 V.
What components are included and what must be purchased separately for installation?
The terminal block itself is supplied; you must source a 1/4 in diameter, 1.25 in length fuse, copper wire between 26 AWG and 8 AWG, and a standard DIN rail for mounting.
Which version should I choose if I need a 1-pole fused disconnect for 10 A circuits on a DIN rail?
This model NSYTRV42SF6LD is a single-pole, 10 A, 600 V fused disconnect terminal block with screw-clamp connections for DIN-rail mounting.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
