Schneider Electric
Schneider Electric NSYTRV42SF6LA Fused Disconnect Terminal Block 1 Pole 10 A
A fused disconnect terminal block for DIN-rail mounting, rated 10 A and 600 V with screw-clamp connections for 26–8 AWG copper wire
- Engine BrandSCHNEIDER ELECTRIC
- 1-pole fused disconnect protects single circuits
- 10 A rating with 600 V maximum voltage
- Screw-clamp terminals accept 26–8 AWG copper wire
- Two-tier DIN-rail mount saves panel space
- CSA, cURus and EAC certified for compliance
Fused Disconnect Terminal Block 1 Pole 10 A
The Schneider Electric NSYTRV42SF6LA is a fused disconnect terminal block rated for 10 A at up to 600 V. It accepts copper conductors from 26 AWG to 8 AWG using screw clamp connections. The unit mounts on DIN rail and provides a single pole with two tiers for compact wiring. It is suited for industrial control panels requiring circuit protection.
Sustained Load Behaviour
The block carries its rated 10 A continuously when a 1/4 in diameter by 1.25 in long fuse is installed and the housing remains within its thermal limits. Screw clamp terminals maintain low contact resistance over time, reducing hotspot formation under steady current. The black housing and CSA, CURus, EAC certifications confirm compliance with recognised safety standards for prolonged operation.
Pre-Installation Checks
Verify that the panel uses standard DIN rail mounting and that the 0.4 in width fits the available slot spacing. Confirm the control circuit voltage does not exceed 600 V and that the fuse holder suits the required 1/4 in by 1.25 in fuse format. Ensure wire preparation matches the 26 AWG to 8 AWG range for solid or stranded copper conductors.
Highlights
- 1-pole fused disconnect protects single circuits
- 10 A rating with 600 V maximum voltage
- Screw-clamp terminals accept 26–8 AWG copper wire
- Two-tier DIN-rail mount saves panel space
- CSA, cURus and EAC certified for compliance
Specifications
| Engine Brand | SCHNEIDER ELECTRIC |
|---|
Questions about this item
How much heat or power loss should I expect from the 10 A fused terminal block when it runs continuously?
The block is rated for 10 A at up to 600 V; actual heat depends on the load current and the fuse you install.
What wire sizes and mounting hardware do I need to install this terminal block?
It accepts 26 AWG to 8 AWG solid or stranded copper wire via screw clamps and mounts on a standard DIN rail.
Will the 1/4 in by 1.25 in fuse format work with the older fuse holders I already have in my panel?
Yes, the block is designed for 1/4 in diameter by 1.25 in length fuses, a common size in many existing panels.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
