Schneider Electric
Schneider Electric NSYTRV42SF6 Fused Terminal Block 10 A 500 V 1 Pole 2 Tier DIN Rail
A fused disconnect terminal block rated 10 A at 500 V with screw-clamp connections for 26–8 AWG copper conductors on DIN rail
- Engine BrandSCHNEIDER ELECTRIC
- Fused protection up to 10 A 500 V
- Screw-clamp connection accepts 26–8 AWG copper
- Two-tier DIN-rail mount saves panel space
- Compact 0.4 in width fits dense layouts
- CSA, CURus and EAC certified for compliance
Schneider Electric NSYTRV42SF6 Fused Terminal Block
The Schneider Electric NSYTRV42SF6 is a fused disconnect terminal block designed for industrial control panels. It provides single-pole circuit protection for copper conductors in automation and electrical distribution systems. Installers use it to integrate fuse holders directly onto standard DIN rail assemblies. This component suits panel builders who need compact overcurrent protection.
Build quality and mounting
The black housing uses screw clamp connections accepting solid or stranded copper wire from 26 AWG to 8 AWG. A two-tier layout separates the fuse holder from the feed-through level within a 0.4 in width. It clips onto DIN rail for secure mounting without tools. The screw clamp terminals ensure reliable contact for power and control circuits.
Thermals noise and power draw
Rated for 10 A at 500 V, the block carries load current through the fuse element without active cooling. Operation is silent as there are no moving parts or fans. Power dissipation depends on the installed fuse rating and load current. The CSA Certified and CURus listed construction meets safety standards for industrial environments.
Highlights
- Fused protection up to 10 A 500 V
- Screw-clamp connection accepts 26–8 AWG copper
- Two-tier DIN-rail mount saves panel space
- Compact 0.4 in width fits dense layouts
- CSA, CURus and EAC certified for compliance
Specifications
| Engine Brand | SCHNEIDER ELECTRIC |
|---|
Questions about this item
What current and voltage does the 500 V fuse terminal block handle?
The block is rated for 10 A at 500 V and accepts fuses up to 1/4 in diameter and 1.25 in length.
What DIN rail width and panel space does the 0.4 in wide two-tier block need?
It clips onto standard DIN rail and occupies 0.4 in width with a 3.11 in by 3.11 in depth and length footprint.
How do you wire the screw-clamp terminals for solid or stranded copper, and what mistake should you avoid?
Strip wire to the clamp length, insert 26–8 AWG solid or stranded copper, tighten the screw clamp, then insert the fuse — skipping the fuse leaves the circuit unprotected.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
