We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small rectangular printhead with metallic finish and connector pins

Sato

Sato GH000771A printhead for CL412E thermal label printer 300 dpi

SKU CH-Z23S-5Z962

Genuine 300 dpi thermal printhead restores sharp barcode output on CL412E label printers

  • Genuine Sato printhead restores original print quality on CL412E
  • Designed for 300 dpi resolution on CL412 and CL412E models
  • Part number GH000771A matches manufacturer specification exactly
  • Single printhead unit supplied ready for installation
  • Direct replacement maintains thermal label printer performance

Genuine printhead for Sato CL412E 300 dpi

This is a genuine Sato replacement printhead bearing part number GH000771A. It is designed specifically for the Sato CL412 and CL412E thermal label printers operating at 300 dpi resolution. The unit is supplied new and includes a single thermal printhead ready for installation.

For maintenance of existing 300 dpi Sato CL412E

This printhead suits technicians and operators maintaining a Sato CL412 or CL412E printer already configured for 300 dpi output. It is not suitable for printers set to a different print resolution or for other Sato printer models that require a different part number.

Part number GH000771A confirms fit for 300 dpi

The decisive specification is the manufacturer part number GH000771A, which identifies this printhead exclusively for the Sato CL412 and CL412E series at 300 dpi. Verifying this part number against the printer service manual is the only way to ensure the correct component is ordered.

Highlights

  • Genuine Sato printhead restores original print quality on CL412E
  • Designed for 300 dpi resolution on CL412 and CL412E models
  • Part number GH000771A matches manufacturer specification exactly
  • Single printhead unit supplied ready for installation
  • Direct replacement maintains thermal label printer performance

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the GH000771A printhead in my CL412E, and what step is often missed?

Power off the printer, open the printhead latch, remove the old head, seat the new GH000771A firmly, close the latch until it clicks, then run a calibration so the 300 dpi alignment registers correctly.

What maintenance will the GH000771A printhead need over time?

Clean the printhead with isopropyl alcohol and a lint-free swab after every roll change; replace it when print quality degrades or after the rated dot-life is reached.

What limit appears first during sustained high-volume printing with this 300 dpi head?

Heat buildup in the thermal elements causes temporary fade or dot dropout before mechanical wear becomes an issue.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.