We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Saramonic

Saramonic SR-SM-C301 3.5mm TRRS male-to-male cable 0.3m

SKU CH-4SM2-RM7RQ

Connects Saramonic SmartMixer to iPhone or iPad via 3.5mm TRRS male-to-male cable, 0.3m length for portable recording setups

  • TRRS connectors on both ends secure reliable audio links
  • Designed for SmartMixer, iPhone and iPad setups
  • TRRS wiring preserves signal clarity for professional recording
  • 3 m length keeps kit light and tangle-free in the field
  • Replacement cable restores SmartMixer-to-iOS connectivity instantly

Saramonic SR-SM-C301 SmartMixer cable

The Saramonic SR-SM-C301 is a 3.5 mm TRRS male-to-male cable built to link the SmartMixer audio interface directly to an iPhone or iPad. Its 0.3 m length keeps the connection tidy for mobile recording rigs.

TRRS wiring decides fit

Both ends carry a 3.5 mm TRRS plug, so the cable only works where a four-pole jack is expected. Devices or interfaces using TS or TRS sockets will not make proper contact with this lead.

Stays reliable on long takes

The short run and moulded strain relief keep resistance low and prevent intermittent crackle during extended sessions. No active electronics means nothing to overheat or drift when the cable is left connected for hours.

Highlights

  • TRRS connectors on both ends secure reliable audio links
  • Designed for SmartMixer, iPhone and iPad setups
  • TRRS wiring preserves signal clarity for professional recording
  • 3 m length keeps kit light and tangle-free in the field
  • Replacement cable restores SmartMixer-to-iOS connectivity instantly

Specifications

No published specifications for this item yet.

Questions about this item

What does the 3.5 mm TRRS connector actually carry when I plug it into my iPhone?

The four-pole plug carries stereo output and a microphone return on a single cable, so the SmartMixer can send a mixed signal to the iPhone while receiving the device's mic input.

Does the TRRS wiring follow the CTIA or OMTP standard used by current iOS devices?

It follows the CTIA pinout used by iPhone and iPad, placing ground on the sleeve and microphone on the second ring for direct compatibility.

Will the 0.3 m length reach from a SmartMixer on a camera rig to an iPhone mounted beside it?

At roughly 30 cm the cable spans a typical side-by-side mount, but leaves no slack for wider rigs or handheld separation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.