Samlex
Samlex 900-RC Remote for Battery Chargers 10 m cable
Remote control with 10 m cable switches the charger on or off and shows charging status from a distance
- 10 m cable enables remote charger control
- 8-position modular connectors ensure secure link
- Remote panel shows charging status clearly
- On/off switching from a distance
- Flat ribbon cable simplifies installation
Remote Control for Samlex Chargers
The 900-RC remote panel lets operators switch a compatible Samlex battery charger on or off and monitor its charging status without standing next to the unit. It is intended for RV owners, marine installers or workshop technicians who need to manage charging from a more convenient location.
Build Quality and Daily Use
A 10 metre flat ribbon cable with 8 position modular male connectors on both ends links the panel to the charger, allowing the remote to be routed through cabinets or bulkheads while keeping a secure plug-in connection. The flat profile helps the cable lie flush against surfaces during permanent installation.
Compatibility Deciding Factor
The remote only works with Samlex chargers that accept the 900-RC interface, so buyers must confirm their charger model supports this specific remote before purchasing. Installers who need a different connector type or a longer cable run will need an alternative solution.
Highlights
- 10 m cable enables remote charger control
- 8-position modular connectors ensure secure link
- Remote panel shows charging status clearly
- On/off switching from a distance
- Flat ribbon cable simplifies installation
Specifications
| Brand | SAMLEX |
|---|
Questions about this item
What does the 8-position modular connector on the 10-metre cable connect to?
The flat ribbon cable carries an 8-position modular male connector at each end; one plugs into the compatible Samlex charger and the other into the remote panel for on/off control and charge-status monitoring.
How is the remote panel mounted in an RV or similar installation?
The panel is designed for surface or flush mounting on a wall or dashboard; secure it with screws through the corner holes and route the flat ribbon cable through a grommeted opening to avoid pinching.
What is the correct sequence to install the remote without losing communication?
Power down the charger, connect both modular plugs firmly until they click, secure the cable away from moving parts, then power the charger back on and verify the panel shows the charging status.
More in Jump Starters, Battery Chargers & Portable Power
Similar items
Same shelf, same checkout — eight coins and a 30-minute rate lock.
