We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two-piece stainless steel clamp collar, 10 mm bore, 24 mm OD, satin finish

Ruland Manufacturing

Ruland Manufacturing MSP-10-SS 2-Piece Clamp Shaft Collar 10 mm 303 Stainless Steel

SKU CH-KQRE-SQGTT

A two-piece clamp shaft collar with a 10 mm bore and 24 mm outside diameter, machined from 303 stainless steel for corrosion resistance

  • Two-piece design allows quick installation on 10 mm shafts
  • 303 stainless steel resists corrosion in harsh environments
  • 24 mm outer diameter fits compact assemblies
  • 3 mm clearance diameter clears adjacent components
  • 9 mm collar width provides secure axial holding

10 mm two-piece clamp shaft collar

This 10 mm bore collar is made from 303 stainless steel and splits into two pieces for installation without removing other components from the shaft. The 24 mm outside diameter and 9 mm width give a compact profile for metric machinery. A 26.3 mm clearance diameter provides room for the socket-head screws during tightening.

Upgrade from single-piece metric collars

The two-piece construction allows fitting or repositioning on an assembled shaft, saving teardown time when a single-piece collar would require sliding off bearings or gears. The jump is worth it when maintenance access is limited or when frequent adjustment is needed on 10 mm shafts.

Handles 10 mm round shafts in corrosive

303 stainless steel resists rust and chemical exposure better than carbon steel equivalents. The collar runs out when a keyway or threaded bore is required, or when the application demands a one-piece design for maximum holding power under reversing loads.

Highlights

  • Two-piece design allows quick installation on 10 mm shafts
  • 303 stainless steel resists corrosion in harsh environments
  • 24 mm outer diameter fits compact assemblies
  • 3 mm clearance diameter clears adjacent components
  • 9 mm collar width provides secure axial holding

Specifications

No published specifications for this item yet.

Questions about this item

Will the 24 mm outside diameter clear my 10 mm shaft and surrounding components?

The collar has a 24 mm outside diameter and a 26.3 mm clearance diameter, so it needs at least that much radial space around the 10 mm bore.

How do I install the two-piece clamp without distorting the bore?

Separate the halves, position them around the shaft, then tighten the stainless-steel screws evenly in a cross pattern to keep the 10 mm bore round.

When should I replace the stainless-steel screws on this 303-grade collar?

Replace the screws if the threads gall, the heads strip, or corrosion appears, since the 303 stainless material can seize under repeated adjustment.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.