We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two-piece stainless steel shaft collar, 60 mm bore, 19 mm wide

Ruland Manufacturing

Ruland Manufacturing 2-Piece Shaft Collar 60 mm 303 Stainless Steel

SKU CH-1YE6-435SG

Two-piece stainless-steel shaft collar clamps a 60 mm round bore with an 88 mm outside diameter and 19 mm width

  • TypeBearings, V-belts & Power Transmission Equipment
  • ColorTransparent
  • Precision fit for 60 mm shafts
  • Two-piece design simplifies installation
  • 303 stainless steel resists corrosion
  • 19 mm width ensures secure grip
  • 88 mm OD and 94 mm clearance fit standard assemblies

Precision shaft collar for 60 mm round shafts

The Ruland Manufacturing two-piece collar clamps onto a 60 mm round bore using stainless-steel screws. Its 303 stainless-steel construction resists corrosion in wash-down or outdoor environments. The split design allows installation or removal without sliding the collar along the shaft.

19 mm wide clamp with 94 mm clearance diameter

The collar measures 19 mm wide and presents an 88 mm outside diameter with a 94 mm clearance diameter. Stainless-steel hardware and material avoid galvanic coupling when paired with stainless shafts. No lubrication or special tools are required for routine adjustment.

Ships free directly from the supplier

The product ships free and direct from the supplier, reducing lead time for maintenance crews. A California Proposition 65 notice applies because the material contains a listed chemical. No additional accessories, lubricants or software are included in the package.

Highlights

  • Precision fit for 60 mm shafts
  • Two-piece design simplifies installation
  • 303 stainless steel resists corrosion
  • 19 mm width ensures secure grip
  • 88 mm OD and 94 mm clearance fit standard assemblies

Specifications

BrandRULAND
TypeBearings, V-belts & Power Transmission Equipment
ColorTransparent

Questions about this item

How do I install the 2-piece 60 mm 303 stainless steel shaft collar without misaligning the clamp halves?

Separate the two halves, place them around the shaft, align the mating faces, then tighten the stainless steel screws evenly in a cross pattern to avoid tilting the 19 mm wide collar.

What maintenance will the 303 stainless steel 2-piece shaft collar need over time?

Periodically check the screw torque, inspect the 60 mm bore and 88 mm outside diameter for wear or corrosion, and retighten if vibration loosens the clamp.

What is the first limit reached when the 60 mm bore collar runs under sustained load?

The clamp holding force on the 60 mm shaft is the limiting factor; if screws loosen, the 19 mm wide collar can shift before the 303 stainless steel material yields.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.