RICOMART No Clean Soldering Flux & Desolder Wick Kit 10cc 10Ft .1
Kit includes 10 cc flux and 10 ft of .1 in wick for fast, low-residue solder removal
- Compatibility/FitmentDsw-flux-kit, Desoldering Wick And Soldering Flux Kit
- Fast solder removal with 10 ft of 0.1" desoldering wick
- Low residue left after use with no-clean flux formula
- High-activity rosin flux breaks down oxide layers quickly
- 10 cc flux pen improves solder flow on joints
- Two-piece kit simplifies PCB rework and component replacement
Soldering Flux & Desolder Wick Kit
The RICOMART kit pairs 10cc of high-activity rosin flux with 10ft of 0.1in desoldering wick for electronics repair. It targets hobbyists and professionals who need to remove solder from printed circuit boards, through-hole parts, and surface-mount devices. The two-piece combo replaces the need to source flux and wick separately.
No-Clean Wick & High-Activity Flux
The wick leaves only a small amount of residue after use, so boards do not require a separate cleaning step. The highly active rosin flux removes the oxide layer on the welding surface to improve solder flow. Together they make tin removal easier and help create strong, reliable connections during rework.
10cc Flux Volume and 10ft Wick Length
The 10cc flux syringe handles multiple board-level repairs before running out. The 10ft roll of 0.1in wick provides enough length for numerous desoldering joints on a single project. Very high-volume production work will exhaust both supplies faster than occasional bench use.
Highlights
- Fast solder removal with 10 ft of 0.1" desoldering wick
- Low residue left after use with no-clean flux formula
- High-activity rosin flux breaks down oxide layers quickly
- 10 cc flux pen improves solder flow on joints
- Two-piece kit simplifies PCB rework and component replacement
Specifications
| Compatibility/Fitment | Dsw-flux-kit, Desoldering Wick And Soldering Flux Kit |
|---|
Questions about this item
When will the 10cc flux pen and 10ft roll of .1" wick need replacing?
The 10cc flux pen lasts until the liquid is used up; the 10ft roll of .1" wick is consumed as each section saturates with solder, so both are replaced once exhausted.
What limits continuous desoldering with the .1" wick and flux?
The .1" wick width and 10ft length set the practical limit; once a section is saturated it must be trimmed, and the flux must be reapplied to keep oxide removal effective during long sessions.
Does the no-clean flux or wick produce fumes or heat during all-day use?
The rosin-based flux releases typical soldering fumes when heated; the wick itself generates no heat but conducts heat from the iron, so ventilation is advised for extended work.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
