RICHELIEU
RICHELIEU BP8818320195 12 5/8 in (320 mm) Center-to-Center Brushed Nickel hardware
A fluted cabinet pull with a 320 mm centre-to-centre measurement and brushed nickel finish includes mounting screws for straightforward installation
- TypeCabinet & Drawer Hardware
- Fluted texture adds visual contrast to smooth posts
- 12 5/8 in center-to-center fits 320 mm spacing
- Brushed nickel finish resists fingerprints and corrosion
- Included 8/32 screws enable quick installation
- California Prop 65 warning discloses chemical content
Cabinet pull for kitchen and bath updates
This Richelieu pull measures 12 5/8 inches center-to-center and 320 millimetres overall. The brushed nickel finish pairs with a fluted texture and smooth posts that have embellished bases. Mounting hardware is included for an easy installation using 8/32 screws. It suits cabinet and drawer upgrades in residential projects.
Fluted texture and smooth posts under daily use
The brushed nickel surface resists fingerprints during repeated handling. The fluted grip area provides tactile control when drawers are fully loaded. Embossed bases distribute stress across the mounting points so the pull stays aligned over time. The 8/32 screws supplied with the unit hold firmly in standard cabinet fronts.
Check centre-to-centre spacing
Verify that your existing holes match the 12 5/8 inch centre-to-centre dimension before ordering. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm. No additional mounting hardware is required beyond the included screws. Ensure the brushed nickel tone matches other fixtures in the room.
Highlights
- Fluted texture adds visual contrast to smooth posts
- 12 5/8 in center-to-center fits 320 mm spacing
- Brushed nickel finish resists fingerprints and corrosion
- Included 8/32 screws enable quick installation
- California Prop 65 warning discloses chemical content
Specifications
| Brand | RICHELIEU |
|---|---|
| Type | Cabinet & Drawer Hardware |
Questions about this item
Does the brushed nickel finish on the BP8818320195 pull show fingerprints after daily kitchen use?
The fluted texture on the grip area helps mask light fingerprints better than a smooth finish, while the smooth posts with embellished bases can be wiped clean with a soft cloth.
What tools and existing holes are needed to install the included 8/32 screws?
A drill with a 4 mm bit for new holes or alignment with existing 320 mm centre-to-centre holes, plus a Phillips screwdriver for the supplied 8/32 mounting screws.
Will the 320 mm centre-to-centre spacing match the hole pattern on my current cabinet doors?
Measure the distance between the centres of your existing mounting holes; if it is exactly 320 mm the pull will line up without drilling new holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
