RICHELIEU
RICHELIEU 7888256195 10 1/8 in 256 mm Center-to-Center Brushed Nickel Cabinet Pull
A rectangular brushed-nickel cabinet pull with curved corners, a sloped grip and 256 mm centre-to-centre spacing, supplied with M4 mounting screws
- TypeCabinet & Drawer Hardware
- Ergonomic grip from sloped rectangular design
- Modern brushed nickel finish suits contemporary interiors
- 256 mm centre-to-centre spacing fits standard cabinets
- Mounting hardware included for straightforward installation
- California Proposition 65 chemical warning applies
Product Identity
This RICHELIEU cabinet pull measures 10 1/8 inches between mounting centres, equivalent to 256 mm. The brushed nickel finish gives a contemporary rectangular profile with curved corners and a sloped grip. It is intended for kitchen cabinets, bathroom vanities or furniture drawers where a modern hardware accent is desired.
Installation Experience
Mounting hardware is included in the form of M4 screws, so no separate fastener purchase is required. Drill two holes at the specified centre-to-centre distance and secure the pull from the front. Misaligned hole spacing is the most common issue; verify the 256 mm measurement before drilling to avoid visible errors.
Pre-Order Checks
Confirm that your doors or drawers are thick enough to accept M4 screw threads without protruding. Ensure the 256 mm centre-to-centre dimension matches existing hole patterns if you are replacing older pulls. Note that the product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- Ergonomic grip from sloped rectangular design
- Modern brushed nickel finish suits contemporary interiors
- 256 mm centre-to-centre spacing fits standard cabinets
- Mounting hardware included for straightforward installation
- California Proposition 65 chemical warning applies
Specifications
| Brand | RICHELIEU |
|---|---|
| Type | Cabinet & Drawer Hardware |
Questions about this item
How do I confirm the 256 mm center-to-center spacing lines up with my cabinet doors after mounting?
Measure the distance between the two screw holes on the installed pull; it should read exactly 256 mm from centre to centre, matching the stated specification.
Does the package include the M4 mounting screws or do I need to purchase them separately?
The manufacturer highlights state that mounting hardware is included, so the required M4 screws come in the box and no separate purchase is needed.
Which finish option should I select if I want the brushed nickel look shown in the product title?
The item is offered specifically in brushed nickel; choose the single listed version to receive that finish.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
