Rfwel Infra
Rfwel Infra Dual Band 2.4/5 GHz Wi-Fi Antenna 7 dBi RP-SMA
Dual-band 2.4/5 GHz Wi-Fi antenna with 7 dBi gain and RP-SMA connector for Wi-Fi 4, Wi-Fi 5, and Wi-Fi 6 routers
- TypeAntenna
- Dual-band 2.4 GHz and 5 GHz coverage extends Wi-Fi reach
- 7 dBi gain focuses signal for stronger links
- RP-SMA male plug fits routers with RP-SMA female jacks
- Flexible rubber-duck design tilts and swivels for optimal aim
- Works with Wi-Fi 4, Wi-Fi 5 and Wi-Fi 6 equipment
Dual-band Wi-Fi replacement antenna
This dual-band antenna replaces the stock whip on routers and access points that use an RP-SMA female jack. It covers the 2.4 GHz and 5 GHz unlicensed bands used by Wi-Fi 4, Wi-Fi 5 and Wi-Fi 6 equipment. The flexible rubber-duck body tilts and swivels so you can orient the element for best coverage. Installation is a simple screw-on swap with no tools required.
Passive element with 7 dBi gain
As a passive antenna it draws no power and adds no fan noise or heat to the system. The 7 dBi figure represents directional gain over an isotropic radiator, concentrating signal toward the horizon rather than boosting total output power. Because it is receive-reciprocal, both transmit range and receive sensitivity improve in the favoured direction. No driver, firmware or configuration change is needed on the host device.
Upgrade for fixed or low-gain stock antennas
The jump is worth it when the supplied antennas are non-removable, limited to 2 dBi or mounted in a metal enclosure that blocks radiation. It also helps when a single access point must reach a distant room or outdoor area without adding a second node. Buyers who need MIMO streams beyond what one element provides, or who require a weather-sealed outdoor radome, should look for multi-element or IP-rated kits instead.
Highlights
- Dual-band 2.4 GHz and 5 GHz coverage extends Wi-Fi reach
- 7 dBi gain focuses signal for stronger links
- RP-SMA male plug fits routers with RP-SMA female jacks
- Flexible rubber-duck design tilts and swivels for optimal aim
- Works with Wi-Fi 4, Wi-Fi 5 and Wi-Fi 6 equipment
Specifications
| Type | Antenna |
|---|
Questions about this item
How do I install the RP-SMA male connector on my router's antenna port?
Screw the RP-SMA male plug clockwise onto the router's RP-SMA female jack until finger-tight; the reverse-polarity pin must align with the jack's centre socket, and over-tightening with tools can strip the threads.
What maintenance will the flexible rubber duck antenna need over time?
The flexible rubber duck radome can be wiped clean with a damp cloth; inspect the hinge for stiffness and the RP-SMA threads for corrosion, replacing the antenna if the swivel loosens or the connector shows green oxidation.
What is the first performance limit I will hit during sustained high-throughput use on the 2.4 GHz band?
The 7 dBi gain focuses signal horizontally, so extended range comes at the cost of reduced vertical coverage; clients directly above or below the antenna will see weaker signal before the radio's own thermal limits are reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Wilson Antennas 305-480 2 ft Silver Load FGT Fiberglass Whip Black antenna
Galtronics 02130269-04935U Indoor Omni Antenna 617-6000MHz 4.3-10 Female
- Antenna
Galtronics 02121269-04935U broadband ceiling mount omni antenna 698-6000MHz
- Antenna mount



