POWER-FENG
POWER-FENG 47Wh PI06 laptop battery for HP ENVY 14 15 Pavilion 17z
47 Wh lithium-polymer battery replaces PI06 and 710416-001 for HP Envy 14, 15 and Pavilion 17z models
- TypeBattery
- Battery TypeLaptop Batteries
- Li-polymer chemistry for stable output
- 47 Wh capacity supports longer sessions
- 8 V rating matches original spec
- Fits HP Envy 14, 15 and Pavilion 17z models
- Replaces nine OEM part numbers including 710416-001
47Wh PI06 replacement battery
This 47Wh lithium-polymer battery operates at 10.8V and supplies 4200mAh of capacity. It matches part numbers including 710416-001 and the PI06, HSTNN-LB4N, HSTNN-LB4O, HSTNN-YB4N, HSTNN-YB4O, HSTNN-UB4N and HSTNN-DB4O codes. The black pack is built for HP Envy 14, Envy 14t, Envy 15 and Pavilion 17z models.
Upgrades worn original cells
It replaces an exhausted factory battery that no longer holds a useful charge. The jump is worth it when runtime has dropped below what you need for a typical work session. Buyers whose laptop requires a different voltage, connector layout or capacity should look elsewhere.
Straightforward swap with care
Installation consists of opening the bottom case, disconnecting the old pack and fitting the new one in the same orientation. What usually goes wrong is forgetting to detach the internal cable before removing screws or forcing the connector the wrong way round. Take a photo of the cable routing before you start.
Highlights
- Li-polymer chemistry for stable output
- 47 Wh capacity supports longer sessions
- 8 V rating matches original spec
- Fits HP Envy 14, 15 and Pavilion 17z models
- Replaces nine OEM part numbers including 710416-001
Specifications
| Type | Battery |
|---|---|
| Battery Type | Laptop Batteries |
Questions about this item
Does the 47Wh PI06 battery fit the HP ENVY 14t and Pavilion 17z chassis?
The battery replaces part numbers PI06, HSTNN-LB4N, HSTNN-LB4O, HSTNN-YB4N, HSTNN-YB4O, HSTNN-UB4N, HSTNN-DB4O and 710416-001, matching HP ENVY 14, 14t, 15 and Pavilion 17z models listed under TPN-Q117 through TPN-Q122 and TPN-I110 through TPN-I112.
What is the first step when installing the 10.8V 4200mAh Li-polymer battery?
Power off the laptop, disconnect the AC adapter, remove the bottom case screws, then disconnect the old battery cable before lifting out the original pack; skipping the cable disconnect risks a short circuit.
When should the 47Wh replacement battery be swapped out again?
Replace it once runtime drops noticeably below the original 47Wh capacity or the pack no longer holds a full 10.8V charge after a complete discharge cycle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



