We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black coaxial cable 10 ft long with silver PL259 connectors on both ends

PISKEKAT

PISKEKAT RG58 Coax Cable 10FT PL259 Male to Male Antenna Cable

SKU CH-JM7N-WKAB7

A 10 ft RG58 coaxial cable with PL259 male connectors on each end for 50 ohm CB and ham radio links

  • TypeOther
  • 10 ft length reaches antennas on Jeeps, Tacomas and campers
  • 50 ohm RG58 design keeps signal loss low
  • Tinned copper centre conductor with brass PL259 plugs resists corrosion
  • 95 % braid coverage plus 96 aluminium wires blocks interference
  • Tested for flat SWR — no added static on CB or ham radio

What this cable connects

This 10FT RG58 coaxial jumper carries 50 Ohm signals between CB and HF amateur radios, antennas, SWR meters, analyzers, tuners, switches, monitors and dummy loads. It also fits car radio installations such as Jeep Wrangler JK, Jeep TJ, Toyota Tacoma and camper vans.

What to verify before ordering

Confirm that both devices you plan to link present PL259 UHF male sockets, because the cable terminates with male connectors on both ends. The run measures 10FT (3m), so ensure the distance between mounting points does not exceed this length.

What it replaces and when the upgrade matters

It replaces worn, corroded or higher-loss jumpers that introduce static or raise SWR readings. The tinned copper inner conductor, brass connectors and 95% braid coverage (96 strands of 0.12/0.14 mm aluminum) keep loss low and resist oxidation, making the swap worthwhile when existing cable degrades signal integrity.

Highlights

  • 10 ft length reaches antennas on Jeeps, Tacomas and campers
  • 50 ohm RG58 design keeps signal loss low
  • Tinned copper centre conductor with brass PL259 plugs resists corrosion
  • 95 % braid coverage plus 96 aluminium wires blocks interference
  • Tested for flat SWR — no added static on CB or ham radio

Specifications

TypeOther

Questions about this item

Does the 10FT RG58 cable arrive with both PL-259 connectors already fitted, or must I crimp them myself?

The cable is supplied as a finished jumper with PL-259 UHF male connectors on both ends, so no additional crimping or parts are required.

When should I choose this 10FT RG58 jumper instead of a longer or shorter version?

Select the 10FT length when the distance between your radio, SWR meter, antenna switch or dummy load is roughly three metres; it keeps loss low while avoiding excess coiled cable.

What does the 50 ohm rating mean when the cable is connected between my CB radio and an SWR meter?

A 50 ohm characteristic impedance matches standard CB and ham equipment, so the meter reads true forward and reflected power without the cable itself adding measurable SWR.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.