Pipe-Pro
Pipe-Pro 278M Magnetic Metal Cutting Guide 2 7/8 in
Magnetic steel guide cuts pipe at 22.5, 45 and 90 degrees with a 2 7/8 in diameter
- TypeWelding Parts & Supplies
- Magnetic hinge holds guide securely on pipe
- Three preset angles: 22.5, 45 and 90 degrees
- Two double-sided templates cover four cutting angles
- Lightweight metal construction resists job-site wear
- Lifetime guarantee backs the tool's durability
Magnetic Cutting Guide 2 7/8 in
The Pipe-Pro 278M is a magnetic metal cutting guide built for pipe fitters, welders and fabricators who need repeatable straight and angled cuts on round stock. Its lightweight steel body clamps magnetically to ferrous pipe, corrals, handrails and roll-cage tubing so the saw or torch follows a fixed path without slipping.
Three preset angles 22.5 45 90 degrees
The guide locks at 22.5, 45 and 90 degrees, letting the operator switch between mitre, saddle and square cuts by flipping the two double-sided templates. This fixed-angle system removes layout guesswork and keeps every joint within the same tolerance across a whole project.
Lifetime guarantee on magnetic hinge
A lifetime guarantee covers the magnetic hinge and metal templates, so the guide stays accurate even after daily site use. The bundled templates store on the tool itself, reducing lost parts and speeding change-over between angles.
Highlights
- Magnetic hinge holds guide securely on pipe
- Three preset angles: 22.5, 45 and 90 degrees
- Two double-sided templates cover four cutting angles
- Lightweight metal construction resists job-site wear
- Lifetime guarantee backs the tool's durability
Specifications
| Type | Welding Parts & Supplies |
|---|---|
| Brand | PIPE-PRO |
Questions about this item
What does the 2 7/8 in diameter mean when I clamp this guide onto pipe?
The guide fits pipe or tube with a 2 7/8 in outside diameter, so the magnetic hinge locks around that size for straight or angled cuts.
Which cutting angles are built into the guide and how do they limit the cut?
The tool includes fixed templates for 22.5°, 45° and 90° cuts; the saw or torch follows those angles and cannot deviate.
What clearance does the magnetic hinge need to sit flat on round tube?
The hinge is low-profile metal; it requires a clean, flat section of the 2 7/8 in tube so the magnets hold without rocking.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
