METRA 82-SU1 speaker adapter and wire harness kit 6.5-6.75 in car electronics accessory
- Speaker Spacers
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pioneer
6.5-inch two-way coaxial speakers deliver 90 watts RMS power with aramid-fiber cones and swivel tweeters for clear highs
The Pioneer TS-D65F is a 6.5 inch 2-way coaxial car speaker system rated at 90 watts RMS and 270 watts maximum power. It uses an aramid fiber IMPP cone with a butyl rubber surround and a 26mm polyester soft dome swivel tweeter. The nominal impedance is 4 ohms and sensitivity is 85 dB. It suits drivers who want a direct factory-location upgrade for clearer sound.
These speakers replace aged or low-output original equipment that lacks bass authority or treble detail. The jump is worthwhile when the existing cones are deteriorating or when the head unit cannot drive the current speakers cleanly at moderate volume. The wide 32 Hz to 49 kHz frequency response and 5200 Hz acoustic crossover point restore missing low-end weight and high-frequency air. Buyers needing deeper sub-bass extension or higher SPL for competition use should look elsewhere.
Under continuous playing the ferrite magnet motor and aramid fiber damper maintain cone control without compression. The 90 watt RMS rating reflects real-world thermal limits rather than a short-term peak. The compact 2-1/2 inch mounting depth fits most door cavities while the metal basket resists flex during extended high-output passages. The swivel tweeter allows off-axis aiming to keep imaging stable during long drives.
| Brand | Pioneer |
|---|---|
| Type | 2-Way Coaxial System |
| Speaker Size | 6.5" |
| Features | 270 Watts Max Power, 90 Watts RMS |
The speakers require a 5-5/8" cutout and have a compact mounting depth of 2-1/2", so verify your door panel clearance before installing.
Connect the speaker to a 4-ohm amplifier channel, observe polarity, and remember to set the head-unit crossover near 5200 Hz acoustic or 3900 Hz electric to match the built-in network.
Inspect the butyl rubber surrounds annually for cracking or hardening; they typically last many years but replace them if you hear air leaks or bass distortion.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?