Peerless
Peerless Chain 5011220 Straight Chain Carbon Steel 20 ft Grade 30 Zinc Plated
Zinc-plated carbon-steel chain, 20 ft long with a 1,300 lb working load limit
- TypeTraffic & Parking Lot
- 20 ft length covers long spans
- Grade 30 carbon steel rated for 1,300 lb working load
- Zinc-plated finish resists outdoor corrosion
- Welded straight links with 10 links per foot
- 57 lb per foot keeps handling light
Grade 30 carbon-steel chain
Peerless Chain 5011220 is a 20 ft length of straight-link proof coil chain made from carbon steel with a zinc-plated finish. It carries a working load limit of 1,300 lb and is rated Grade 30 for general-purpose tying, binding and barrier applications. Each foot contains ten welded links measuring 1 1/4 in inside length by 1/2 in inside width. The chain weighs 0.57 lb per foot and has a material thickness of 17/64 in.
Suits general utility and traffic control
This chain fits buyers who need a 20 ft zinc-plated Grade 30 length for securing loads, marking parking areas or creating temporary barriers. It is not for lifting, overhead rigging or any application that requires a higher-grade alloy chain. Users who need a hook already attached or a different trade size should look at other options.
Working load limit 1,300 lb
The 1,300 lb working load limit is the single figure that determines whether this chain meets the load requirement for a given task. Verify that the expected tension stays within this limit before use.
Highlights
- 20 ft length covers long spans
- Grade 30 carbon steel rated for 1,300 lb working load
- Zinc-plated finish resists outdoor corrosion
- Welded straight links with 10 links per foot
- 57 lb per foot keeps handling light
Specifications
| Brand | PEERLESS |
|---|---|
| Type | Traffic & Parking Lot |
Questions about this item
Will the 1/4 in trade size and 1/2 in inside link width let this chain pass through my existing hardware?
The trade size is 1/4 in and each link has an inside width of 1/2 in, so check your shackle or hook pin diameter against those dimensions before ordering.
How do I cut or join the 20 ft welded proof coil chain without weakening the 1,300 lb working load limit?
Because every link is welded, you must use a compatible 1/4 in connecting link or cold shut rated for Grade 30 rather than re-welding, which would reduce strength.
How often should I inspect the zinc-plated carbon steel links for corrosion or wear?
Inspect before each use; the zinc finish resists rust but outdoor exposure will eventually wear it, so replace any link showing pitting, elongation or cracked welds.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
