Peach Country
Peach Country Heat Hardened Edger Blades 2" x 8" x .120" 5 pack
Heat-hardened edger blades with a rust-resistant oil finish, supplied unsharpened in a five-pack
- TypeEdger Blades
- Heat-hardened steel resists wear for longer edging life
- Rust-resistant oil finish protects blades during storage
- Fits Echo, Husqvarna, Stihl and other major brands
- Five-blade pack keeps a spare set ready for swaps
- Made in the USA from tough domestic steel
Peach Country Edger Blades 5 Pack
These heat-hardened edger blades measure 2 inches wide by 8 inches long with a 1 inch centre hole and .120 inch thickness. The pack contains five unsharpened blades made in the USA from rust-resistant steel with an oil finish. They are designed as direct replacements for many common edger models.
Fits Echo Husqvarna Stihl and more.
The blades replace original parts from Echo, Green Machine, Husqvarna, Marymama, Red Max, Ryobi, Shindaiwa and Stihl as listed in the specifications. Buyers whose edger requires a different centre hole diameter or blade length should look for a matching specification.
1 inch centre hole decides fit
The single critical specification is the 1 inch centre hole that must match the edger spindle exactly. If the machine uses a different hole size these blades will not mount regardless of the outer dimensions.
Highlights
- Heat-hardened steel resists wear for longer edging life
- Rust-resistant oil finish protects blades during storage
- Fits Echo, Husqvarna, Stihl and other major brands
- Five-blade pack keeps a spare set ready for swaps
- Made in the USA from tough domestic steel
Specifications
| Brand | Peach Country |
|---|---|
| Type | Edger Blades |
Questions about this item
Which edger shaft size fits the 1" center hole on these blades?
The blades have a 1 inch center hole designed for edgers that use a 1 inch mounting bolt.
Will these 8" diagonal blades replace the Echo 720237001 on my older edger?
Yes, they are listed as a direct replacement for Echo 720237001 and several other OEM part numbers.
How can I confirm the blades are installed correctly after mounting them?
The blade should sit flat against the flange, the 1 inch center hole must align with the drive bolt, and the edger should run without wobble.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
