Panduit
Panduit Grounding Busbar Copper 10in GB2B0304TPI-1
Copper grounding busbar, 10 in long with 3/8 in and 1/4 in holes, meets BICSI/TIA-607-C and cULus standards
- Copper construction ensures reliable conductivity for telecom grounding
- 10 inch length fits standard rack and cabinet installations
- Three 3/8 inch and four 1/4 inch holes support multiple conductor sizes
- Meets BICSI/TIA-607-C and cULus standards for code compliance
- Quarter inch thick bar provides mechanical strength for permanent mounting
Grounding Busbar for Telecom and Data Centers
This copper grounding busbar is built for telecom and data-center installations that require a reliable equipotential bonding point. The bar measures ten inches long, two inches wide and a quarter inch thick. It meets BICSI and TIA-607-C standards and carries a cULus listing for code-compliant deployments.
Connection Pattern and Conductor Limits
The bar provides three holes sized for three-eighths inch hardware and four holes sized for quarter-inch hardware. This fixed hole pattern determines the maximum number and size of lugs that can be terminated directly on the bar. Installers must match their conductor lugs to these two bolt diameters; no additional hole sizes or spacing options are available.
Capacity and Headroom in Typical Racks
The ten-inch length fits standard relay rack widths while leaving enough hole density for multiple grounding conductors in a single row. The solid copper cross-section handles high fault currents required by the listed standards. The bar ships without ground wire, so the final ampacity depends on the conductors and lugs the installer selects.
Highlights
- Copper construction ensures reliable conductivity for telecom grounding
- 10 inch length fits standard rack and cabinet installations
- Three 3/8 inch and four 1/4 inch holes support multiple conductor sizes
- Meets BICSI/TIA-607-C and cULus standards for code compliance
- Quarter inch thick bar provides mechanical strength for permanent mounting
Specifications
| Brand | PANDUIT |
|---|
Questions about this item
Should I choose the 10 in busbar or a different length for my rack?
This model is the 10 in length with 2 in width and 1/4 in thickness. Select it when the mounting space and hole pattern match your rack layout.
What does the 1/4 in thickness mean for current capacity once installed?
The solid copper bar is 1/4 in thick and 2 in wide, providing a large cross-section for low-impedance grounding in telecom and data-centre racks.
Which standard applies to the mounting holes and what does it limit?
The hole pattern follows BICSI/TIA-607-C with three 3/8 in and four 1/4 in holes, limiting lug sizes to those bolt diameters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
