Onsrud
Onsrud 37-01 engraving tool carbide 0.005 in 60 deg hand tool
Carbide engraving tool with a 60-degree tip and 0.005 inch width for precise marking
- TypeHole, Drill, Bore & Wire Gauges
- Carbide construction resists wear for longer tool life
- 60-degree tip angle produces clean V-groove cuts
- 005-inch tip width enables fine detail engraving
- Uncoated carbide suits a variety of workpiece materials
- Single-piece design simplifies setup in hand-held use
Precision Engraving Tip 0.005 in
The Onsrud 37-01 is a carbide engraving tool ground to a 0.005 inch tip with a 60 degree included angle. It is supplied new and uncoached for clean cuts in a variety of materials. This hand tool suits detail work where a fine point is required.
Replaces Worn Fine-Point Cutters
The tool replaces an engraving tip that has dulled or chipped at the 0.005 inch size. The jump is worth it when the previous cutter no longer holds a sharp edge at this diameter. A 30 degree variant exists for different groove profiles.
Simple Collet Swap
Installation consists of placing the shank into a compatible collet or holder and tightening securely. What usually goes wrong is running the tool without confirming the holder runs true, which snaps the fine carbide point immediately.
Highlights
- Carbide construction resists wear for longer tool life
- 60-degree tip angle produces clean V-groove cuts
- 005-inch tip width enables fine detail engraving
- Uncoated carbide suits a variety of workpiece materials
- Single-piece design simplifies setup in hand-held use
Specifications
| Brand | Onsrud |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
What shank diameter fits the Onsrud 37-01 engraving tool?
The tool has a 1/2 in. shank that fits standard 1/2 in. collets or holders used on CNC routers and engraving spindles.
How is the 30 degree carbide tip installed, and what step is often missed?
Insert the tool into the collet until the shank seats fully, then tighten the collet nut to the machine maker's torque spec; the step often missed is verifying the tip runs true with a dial indicator before cutting.
When will the 0.005 in. tip need replacement?
Replace the tip when the 0.005 in. point shows visible wear, chipping, or when engraving quality drops, typically after extended use in abrasive materials.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
