Omnicel
Omnicel ER14250 1/2 AA 3.6V 1200mAh lithium battery 24-pack
Twenty-four 1/2 AA lithium thionyl chloride cells deliver 3.6 volts and 1200 mAh for long-life industrial use
- 24-pack supplies long-term power for multiple devices
- 1200 mAh capacity supports extended runtime in low-drain applications
- 6 V nominal voltage matches 1/2 AA form-factor requirements
- Lithium thionyl chloride chemistry operates from -55 °C to +85 °C
- UL-approved cells meet recognised safety standards
24-pack 1/2 AA lithium thionyl chloride cells
This 24-pack supplies Omnicel ER14250 primary lithium batteries rated at 3.6V and 1200mAh. Each cell uses lithium thionyl chloride chemistry in a 1/2 AA form factor measuring 14.5mm diameter by 25.25mm height. They are intended for devices that require a stable 3.6V nominal voltage and long shelf life.
Replaces common ER14250 and LS14250 equivalents
The cells are direct replacements for Tadiran TL-5902, TL-2150, TL-5151, Saft LS-14250 and other listed ER14250 cross-references. The jump is worth it when a device demands the high energy density and wide temperature range of primary lithium rather than alkaline or rechargeable alternatives. Do not mix different models in series.
Performance across -55C to +85C operating range
Rated operation spans -55C to +85C with storage recommended below +30C. The chemistry delivers consistent voltage under sustained low-current loads rather than high pulse bursts. These batteries are not rechargeable; do not attempt recharging and avoid use if casing is damaged.
Highlights
- 24-pack supplies long-term power for multiple devices
- 1200 mAh capacity supports extended runtime in low-drain applications
- 6 V nominal voltage matches 1/2 AA form-factor requirements
- Lithium thionyl chloride chemistry operates from -55 °C to +85 °C
- UL-approved cells meet recognised safety standards
Specifications
No published specifications for this item yet.
Questions about this item
What are the diameter and height of each ER14250 cell so I can confirm it fits my device?
Each cell measures 14.5 mm in diameter and 25.25 mm in height.
How should I install these primary lithium cells to avoid damage?
Insert them with correct polarity; never solder directly to the cell for more than a few seconds and do not mix different models in series.
When will these 1200 mAh Li-SOCl2 batteries need replacement in a low-drain application?
They are non-rechargeable; replace them once the open-circuit voltage drops below the 3.6 V nominal level your equipment requires.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



