NUOLAISUN
NUOLAISUN 16.0" WUXGA 1920x1200 30-pin Touch Screen FRU 5D10S39792/39793/39794
16.0-inch WUXGA 1920x1200 30-pin touch screen replacement for Lenovo IdeaPad Flex 5 models
- WUXGA 1920x1200 resolution delivers sharp visual detail
- 0 inch touch display enables direct on-screen control
- 30-pin connector matches original Lenovo FRU specifications
- Compatible with IdeaPad Flex 5 16ALC7 and 16IAU7 models
- Brand-new replacement screen supplied as LCD assembly only
16.0" WUXGA Touch Replacement Screen
This 16.0 inch display replaces the panel in compatible Lenovo IdeaPad Flex 5 models. It delivers WUXGA 1920x1200 resolution with integrated touch digitizer. The assembly arrives as a new LCD screen only, intended for professional installation.
FRU 5D10S39792 39793 39794 Match
The part matches FRU numbers 5D10S39792, 39793 and 39794 used across several Flex 5 16ALC7 and 16IAU7 units. Upgrade is justified when the original panel is cracked, shows dead pixels, or loses touch response. Internal model variations exist, so confirming the exact FRU avoids ordering an incompatible unit.
Verify 30-Pin Connector Before Ordering
Check the back of your current screen for the printed FRU or a clear photo of the label. Confirm the video cable uses a 30-pin interface and that the mounting brackets align. Disconnect the power adapter and battery cable before starting the swap, and keep the original packaging sealed if the part proves incorrect.
Highlights
- WUXGA 1920x1200 resolution delivers sharp visual detail
- 0 inch touch display enables direct on-screen control
- 30-pin connector matches original Lenovo FRU specifications
- Compatible with IdeaPad Flex 5 16ALC7 and 16IAU7 models
- Brand-new replacement screen supplied as LCD assembly only
Specifications
No published specifications for this item yet.
Questions about this item
Will the 30-pin connector on this 16.0" WUXGA touch panel match the cable on my Lenovo IdeaPad Flex 5 16ALC7 or 16IAU7?
Yes — the screen carries FRU numbers 5D10S39792, 39793 and 39794, which are the exact part codes Lenovo specifies for those two models, so the 30-pin interface aligns with the factory cable.
What is the one installation step people skip that can damage the new digitizer assembly?
Disconnect both the AC adapter and the internal battery cable before removing the old screen; the supplier stresses that power must be fully removed or the fragile glass assembly can short out during swap.
If the touch layer develops dead zones later, what part must be replaced?
The digitizer is bonded to the LCD in a single assembly, so any touch failure means replacing the whole 16.0" WUXGA 1920×1200 touch-screen unit rather than a separate glass layer.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



