We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee with three sweat connections, 2 by 2 by 1 inch

Nibco, Inc.

Nibco, Inc. U611 2x2x1 copper trap

SKU CH-B9TJ-0QXA6 MPN U611

Reducing tee joins 2-inch and 1-inch copper lines with wrot copper construction rated to 364 psi at 100 degrees Fahrenheit

  • TypeDrain Components
  • Reducing tee connects three copper lines
  • Wrot copper construction resists corrosion
  • Rated 364 psi at 100 degrees F
  • Operates from -20 to 400 degrees F
  • Meets ASME/ANSI B16.22 standard

Copper Reducing Tee for Drain Systems

The Nibco U611 is a wrot copper reducing tee designed for drain component assemblies. It connects three copper tubes in a C x C x C solder configuration. The branch reduces from a 2-inch run to a 1-inch outlet. Plumbers and contractors use it for residential and commercial drainage installations.

364 psi Rating with Wide Temperature Range

The fitting withstands a maximum pressure of 364 psi at 100 degrees F. Its operating temperature spans -20 degrees to 400 degrees F, providing headroom for hot-water drain lines and cold environments. Copper construction resists corrosion in typical drain applications. The ASME/ANSI B16.22 compliance confirms dimensional and material standards.

Replaces Mismatched or Damaged Copper Tees

This tee upgrades worn, leaking, or incorrectly sized copper fittings in existing drain networks. The jump is worth it when a 2 x 2 x 1 inch reduction is required and the system operates within the rated pressure and temperature limits. It is not suited for press-fit or threaded pipe systems, nor for applications exceeding the 364 psi or 400 degree F boundaries.

Highlights

  • Reducing tee connects three copper lines
  • Wrot copper construction resists corrosion
  • Rated 364 psi at 100 degrees F
  • Operates from -20 to 400 degrees F
  • Meets ASME/ANSI B16.22 standard

Specifications

TypeDrain Components
BrandNibco
ModelU611 2x2x1

Questions about this item

Will the 2-inch ends of this U611 reducing tee solder cleanly to the existing 2-inch copper mains in my house?

Yes, each end is a C x C x C solder cup made from wrot copper, so the 2-1/8 inch outside diameters accept standard 2-inch copper tube with flux and lead-free solder.

How can I confirm the joint is holding at the rated 364 psi after I solder the tee in place?

Pressurise the system with water to the working pressure, then inspect every soldered cup for drips; the fitting meets ASME/ANSI B16.22 and is rated to 364 psi at 100 °F.

Does the box include flux, solder or pipe hangers, or must I buy those separately?

The package contains only the wrot copper reducing tee itself; flux, solder, hangers and any transition fittings are separate purchases.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.