We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper 90 degree elbow fitting model 607LT

Nibco, Inc.

Nibco, Inc. 607LT 90° Elbow Trap

SKU CH-1C2A-NAAAQ MPN 607LT

A copper 90-degree elbow for 1/2-inch tube in drain and trap installations

  • TypeDrain Components
  • 90-degree elbow routes copper tubing efficiently
  • Wrot copper construction resists corrosion in plumbing systems
  • 1/2 inch tube size fits standard supply lines
  • Model 607LT identifies the fitting for reordering

90-Degree Elbow Trap for Copper Piping

This Nibco 607LT elbow trap creates a 90-degree turn in half-inch copper pipe systems. The wrought copper construction suits mechanical and plumbing installations where a durable, corrosion-resistant fitting is required. It connects directly to 1/2 inch nominal tubing with a 5/8 inch outside diameter.

Thermals, noise and power draw in normal use

As a passive copper fitting, this elbow trap generates no heat, produces no noise and draws no electrical power during operation. Performance depends entirely on the surrounding piping system and fluid dynamics rather than any active components.

Highlights

  • 90-degree elbow routes copper tubing efficiently
  • Wrot copper construction resists corrosion in plumbing systems
  • 1/2 inch tube size fits standard supply lines
  • Model 607LT identifies the fitting for reordering

Specifications

TypeDrain Components
BrandNibco
Model607LT 1/2

Questions about this item

How do I install the 607LT 90° elbow trap correctly, and what step is commonly missed?

Clean the 1/2" tube ends, apply flux evenly, insert fully into the wrought copper sockets, then heat each joint uniformly until solder flows around the entire circumference; the step often missed is heating both sockets evenly so the solder draws into both cups.

What maintenance or replacement will the 607LT 90° elbow trap need over time?

The wrought copper fitting itself requires no scheduled maintenance; inspect joints periodically for green corrosion or leaks, and replace only if a joint fails or the system is re-piped.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.