NDLIULEI
NDLIULEI M2D068-CF 400V 64W 210mm Axial Industrial Cooling Fan
Axial fan delivers 64 W airflow at 400 VAC, 50 Hz, 2700 min⁻¹, IP44 rated, −40 °C to 80 °C range, 210 mm diameter
- TypeCase Fan
- Operates reliably in extreme cold and heat from -40°C to 80°C
- Delivers strong airflow at 2700 RPM with 64 W power draw
- IP44 protection class resists dust and water splashes in harsh environments
- CE approved for compliance with European safety standards
- Runs on 400 VAC three-phase supply at 50 Hz frequency
Industrial axial fan for 400 V systems
This 210 mm axial fan operates on 400 VAC at 50 Hz and draws 64 W at 0.33 A. It spins at 2700 min⁻¹ and carries CE approval with an IP44 protection rating. The unit is supplied new in single-fan packaging.
Capacity and headroom for continuous airflow
At the rated 64 W the fan delivers steady airflow for industrial enclosures and HVAC ducting within the -40 °C to 80 °C ambient range. The IP44 ingress protection handles splashing water but is not rated for immersion or high-pressure washdown. Operation beyond the specified voltage or frequency range is not supported.
Thermals noise and power draw in normal use
The motor runs at 2700 min⁻¹ while consuming 64 W, producing audible airflow noise typical of industrial axial designs. Heat generated by the motor stays within the wide -40 °C to 80 °C operating envelope without additional cooling. The 0.33 A current draw remains stable across the 50 Hz supply.
Highlights
- Operates reliably in extreme cold and heat from -40°C to 80°C
- Delivers strong airflow at 2700 RPM with 64 W power draw
- IP44 protection class resists dust and water splashes in harsh environments
- CE approved for compliance with European safety standards
- Runs on 400 VAC three-phase supply at 50 Hz frequency
Specifications
| Type | Case Fan |
|---|
Questions about this item
Will this 210 mm axial fan fit the same mounting pattern as the 400 V unit I am replacing?
The fan has a 210 mm blade diameter and is an axial type; verify your existing cutout and hole spacing against those dimensions before installation.
How can I confirm the fan is running at the rated 2700 min⁻¹ after wiring it to 400 VAC 50 Hz?
Measure the rotational speed with a tachometer; it should read approximately 2700 min⁻¹ when supplied with 400 VAC at 50 Hz.
Does the package include a power cord or mounting screws, or must I source them separately?
The box contains only the fan itself; a power lead and any mounting hardware need to be obtained separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
